Volkswagen Golf / Golf GTI / Jetta. Manual — part 164
01-198
Display group 6 - Basic function
Engine running at idle
Read measured value
block 6
Indicated on
display
xxxx
rpm
xxx.x
%
xxx.x
C
xx.x
%
1
2
3
4
Display zones
Specification
Evaluation
Elevation
correction factor
-50.0...20.0 %
---
Intake air temperature
-37.0...126.0
C
Page 01-
196
Engine load
12.0...26.0 %
Page 01-
201
Engine speed (idle speed)
640...720 rpm
Page 01-
188
Note on display zone 2:
The engine load at idling is given as the specification.
Note on display zone 3:
The total temperature range is given as the specification. The displayed value must be
above ambient temperature.
Measured value (data) blocks
01-199
Display group 8 - Basic functions - Brake System Vacuum Pump (automatic
transmission only)
Ignition on, engine not running
Read measured value
block 8
Indicated on
display
Text
xx.xxx
V
Text
xxx
mbar
1
2
3
4
Display zones
Specification
Evaluation
Brake servo,
absolute pressure
---
---
Brake System Vacuum
Pump -V192-
(pump ON / pump OFF)
---
---
Voltage supply for Motronic Engine
Control Module (ECM) -J220-
11.500...15.000
V
Page 01-
194
Brake pedal:
Not operated
Operated
not oper.
operated
---
---
Measured value (data) blocks
01-200
Measured value blocks, display groups 10...29 - Ignition, evaluating
Display group 10 - Ignition
Engine running at idle
Read measured value
block 10
Indicated on
display
xxxx
rpm
xxx.x
%
xxx.x
%
xx.x
BTDC
1
2
3
4
Display
zones
Specification
Evaluation
Ignition timing
angle
4.0...15.0
BTDC
---
Throttle valve angle
Angle sensor -1- for throttle
drive -G187-
0.2...4.0 %
Page 01-
202
Engine load
12.0...26.0 %
Page 01-
201
Engine speed (idle speed)
640...720 rpm
Page 01-
188
Note on display zone 2:
The engine load at idling is given as the specification.
Note on display zone 3:
Display values must be approx. 100 % when accelerator pedal is fully depressed.
Measured value (data) blocks
01-201
Evaluating display group 10, display zone 2 - Engine load
Appears on
display
Possible cause
Corrective action
Less than
specified
Lower values can only occur
when driving in overrun
---
Greater than
specified
Rough idling (not running on
all cylinders)
- Check spark connectors
Page
28-15
, Test data, spark
connectors
- Check ignition coils with power
output stage
Page 28-23
Mass Air Flow (MAF) Sensor
-G70- faulty
- Check Mass Air Flow (MAF)
Sensor -G70-
Page 24-52
Fuel injector faulty
- Check fuel injectors
Page 24-
97
Throttle Valve Control
Module -J338- sticking/faulty
- Check Throttle Valve Control
Module -J338-
Page 24-59
Electric consumers switched
on
- Switch off electric consumers
Steering wheel at full lock
- Set steering wheel to center
position
Gear selected (automatic
transmission)
- Place selector lever in P or N
Measured value (data) blocks
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст