Volkswagen Golf / Golf GTI / Jetta. Manual — part 277
34-22
Gear selector mechanism,
adjusting
Special tools and equipment
Note:
The following points are essential to
ensure correct selector adjustment:
T10027 Pin
Moving parts of the selector
mechanism and transmission
elements must be in proper
condition.
Selector mechanism must move
freely.
The transmission, clutch and
clutch mechanism must also be
in proper condition.
Transmission in neutral position
- Secure locking mechanism on
gear selector cable and gate
selector cable by pulling forward
until stop (arrow -1-) and then
turning to left to lock (arrow -2-).
Gear selector mechanism, servicing
34-23
Set selector shaft as follows:
- Carefully press selector shaft
down (direction of arrow -1-).
- While pressing selector shaft
down, push locking pin -A- into
transmission (direction of arrow)
until it engages.
Selector shaft is now locked and
cannot be moved any more.
- Pull shift lever cover off center
console (arrow).
- Pull cover to rear off center
console.
Gear selector mechanism, servicing
34-24
Set shift lever as follows:
- Guide shift lever in neutral to left
into gate for 1st/2nd gear.
- Guide pin T10027 through hole -
A- and into hole -B-.
- Turn locking mechanism on gear
selector cable and gate selector
cable to right onto stop (direction
of arrow).
Spring presses locking
mechanism into normal position.
Gear selector mechanism, servicing
34-25
- Pull locking pin -A- back to
original position (direction of
arrow).
- Pull pin T10027 out of holes -A-
and -B-.
- Clip cover into frame.
Gear selector mechanism, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст