Volkswagen Golf / Golf GTI / Jetta. Manual — part 335
01-6
Safety precautions
The ABS is a vehicle safety system; the
appropriate knowledge is necessary to work on
the system.
In order to check complaints and to be able to
carry out pin-pointed troubleshooting, the
Diagnostic Trouble Code (DTC) memory must
be checked before beginning work on the ABS
system.
Only separate connectors when the ignition is
switched off.
Observe the appropriate instructions regarding
the handling of brake fluid.
Repair Manual, Brake System, Repair Group
47
ABS malfunctions are indicated by the ABS
warning light illuminating. Certain malfunctions
will only be recognized at speeds above 20
km/h (approx. 13 mph) (carry out road test).
If the ABS Warning Light -K47- and the warning
light for brake system -K118- do not light up,
but the brake system is not functioning correctly
then the malfunction must be sought in the
conventional braking system.
Repair Manual, Brake System; Repair Group
45
ABS ITT Mark 20 IE On Board Diagnostic (OBD)
01-7
On Board Diagnostic (OBD) with V.A.G 1551 Scan Tool or Tester VAS
5051 (flow chart)
Connect V.A.G 1551 and select 1-
rapid datatransfer
or
Connect tester
VAS 5051 and
select vehicle
OBD
Compare control
module
identification
Select address word 03-Brake
electronics
Check DTC memory
02
Repair DTCs using DTC table
No DTCs
recognized
Read
measured
value block 08
Perform output Diagnostic
Test Mode (DTM) 03
Replace
component
1. Perform test drive at more
than 20 km/h
2. Check DTC memory 02 again
3. "No DTCs recognized" is
displayed again
A B C
D
E
ABS ITT Mark 20 IE On Board Diagnostic (OBD)
01-8
A B
C D
E
Perform directed
entry of electrical
tests
Service
hydraulic/mechanical
parts of brake system
(
Repair Manual)
1. Perform all test
steps of electrical
checks
Page 01-
102
Identification not OK.
2. Service
hydraulic/mechanical
parts of brake
system
(
Workshop
Manual)
Replace control module
- Connect V.A.G 1551 and check DTC memory again (02).
- Erase DTC memory (05)
- Perform test drive at more than 20 km/h (13 mph) and allow the ABS to
regulate braking.
- Check DTC memory again after test drive. If "No DTC recognized"
appears on display of V.A.G 1551 after repairing DTCs and performing
test drive the On Board Diagnostic (OBD) is completed.
ABS ITT Mark 20 IE On Board Diagnostic (OBD)
01-9
Electrical/electronic
components and
locations
Repair Manual, Brake
System, Repair Group 45
1 - ABS hydraulic unit
N55-
Located on left of
engine compartment.
The ABS hydraulic
pump -V64-
inlet/outlet valves in the
hydraulic unit are
checked by On Board
Diagnostic (OBD)
The ABS Hydraulic
Pump -V64
block must not be
separated from one
another
Removing and
installing:
When changing the
hydraulic unit, always
seal the old part with
the plugs from the
repair set Part No. 1H0
698 311 A
Electrical/electronic components and locations
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст