Volkswagen Golf / Golf GTI / Jetta. Manual — part 446
46-33
Brake pads, removing and
installing
Special tools and equipment
required
Removing
Note:
If reusing brake pads mark location
and install in same position when
installing otherwise uneven braking
will occur!
V.A.G 1331 Torque wrench
Piston resetting tool
- Remove wheels.
- Secure brake disc using a wheel
bolt.
Front brakes
46-34
- Press retaining spring so far in
direction of (arrow -A-) until it can
be pressed out of the bore of the
brake caliper.
- Then, pull bottom of retaining
spring in direction of (arrow -A-)
and hold this position. Now press
top of retaining spring in direction
of (arrow -B-). At the same time,
the retaining spring must be
turned slightly counter-clockwise
and be pulled out of the bore of
the brake caliper (arrow -D-).
Front brakes
46-35
- Separate connector -1- from
brake pad wear indicator.
- Remove harness for brake lining
wear indicator from retainer -2- of
the upper cap and out of retainer -
3- of the protective cap.
Note:
Upper protective cover with cable
holder for brake pad wear indicator
- Remove protective caps -1-.
Front brakes
46-36
Use methylated spirit only for
cleaning brake caliper housing.
Installing
Note:
Before inserting new brake pads,
press piston back into the cylinder
with resetting tool. Before pressing
the piston back, draw off brake fluid
from the reservoir with a bleeder
bottle. Otherwise particularly if
reservoir has been topped off, fluid
will overflow and cause damage.
- Remove both guide pins from
brake caliper.
- Take off brake caliper housing
and lay to one side so that the
weight of the brake caliper does
not stress or damage brake hose.
- Take brake pads out of brake
caliper housing or from brake
carrier.
- Press piston back.
Front brakes
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст