Volkswagen Golf / Golf GTI / Jetta. Manual — part 92
muffler and
rear muffler
are supplied
individually
with a double
clamp for
connecting
together.
Separating
points
Fig.
4
Observe
installation
position of
end pipe
Fig. 5
Exhaust system components, servicing
26-10
10
-
Support
element/mounting
11 - Tunnel bridge
With hole to
align exhaust
system
Aligning
exhaust
system
Page 26-14
Exhaust system components, servicing
26-11
Note:
Mark -A- is valid for models with a
manual or an automatic
transmission.
Fig. 1
Installation position of
double clamp
- Position new double clamp, as
illustrated, approx. 5 mm from
markings -A- and tighten.
Tightening torque: 40 Nm
Mounting pins on exhaust pipe must
run parallel with tunnel bridge
(dimension -x- on left and right the
same).
Fig. 2
Aligning forward muffler
parallel
Exhaust system components, servicing
26-12
Angled side on base of mounting
(arrow) points forward.
Fig. 3
Installation position of
mounting
Special tools and equipment
Fig. 4
Separating point on
exhaust pipe
Body saw e.g. VAG 1523
- Separate exhaust pipe at right
angles at separating point (arrow
-2-).
- Align repair double clamp -4- in
installation position on side
markings (arrows -1- and -3-) as
illustrated.
Tightening torque: 40 Nm
Exhaust system components, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст