Volkswagen Golf / Golf GTI / Jetta. Manual — part 924
01-33
Output Diagnostic Test Mode
Self test
Indicated on display:
The following tests are performed:
After approx. 30 seconds, the
checks are completed.
A/C control head -E87- display
Page 01-34
Functional test of the 4 flap
motors
Electrical circuit to fresh air
blower -V2- is tested.
Climatronic control module
switching sequence for A/C
clutch -N25- is tested.
All sensors are checked.
Function is not recognized or cannot
be performed at the moment!
Indicated on display:
Note:
After completing output DTM, always
check DTC memory
Page 01-12
.
- If "Function is not recognized or
cannot be performed at the
moment" appears in display,
output DTM has been concluded.
- Press
button.
Climatronic On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-34
A/C control head -E87- display,
checking
All display segments must show.
Note:
All display segments must appear
during output DTM, otherwise
replace Climatronic control module -
J255-.
Climatronic On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-35
Basic setting (function 04)
Note:
If the display flashes after switching ignition on,
even though no Diagnostic Trouble Codes (DTC)
are in DTC memory, perform function 07 Code
Control Module followed by function 04 Basic
setting.
- Connect VAG 1551 Scan Tool (ST), enter
address word 08 "AC./Heating electronics" and
press
until "Select function XX" appears in
display
Page 01-8
.
- Switch printer on by pressing PRINT button
(warning lamp in button lights up).
- Check DTC memory
Page 01-12
and correct
all malfunctions shown.
- Erase DTC memory
Page 01-39
- Check code
Page 01-41
and correct if
necessary.
Climatronic On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-36
Rapid data transfer
HELP
Select function XX
Indicated on display (function
selection):
- Press buttons -0- and -4- to select
function 04 Basic setting.
Rapid data transfer
Q
04 - Basic setting
Indicated on display:
- Press -Q- button to confirm entry.
Basic setting
HELP
Enter display group number XXX
Indicated on display:
- Enter display group number 000
Basic setting
Q
Enter display group number 000
Indicated on display:
Note:
The Climatronic control module -
J255- stores all flap motor position
sensor (potentiometer) values when
moving to their final positions and
therefore takes on the basic setting
of all flap motors.
- Press -Q- button to confirm entry.
Climatronic On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст