Volkswagen Golf / Golf GTI / Jetta. Manual — part 325
39-5
Removing
Transmission is mounted in vehicle.
- If installed, remove center and right part of
sound insulation tray below engine/transmission.
- Turn steering to right onto full lock stop.
- Remove axle shaft.
Repair Manual, Suspension, Wheels,
Steering, Repair Group 40
- Remove flanged shaft securing bolts by
threading two bolts into flange and
counterholding flanged shaft using a lever.
- Place container under transmission.
- Remove flanged shaft with spring.
- Pry seal out with lever.
Oil seals for flanged shafts, replacing
39-6
Installing
Repair Manual, Suspension,
Wheels, Steering, Repair Group 40
Repair Manual, Suspension,
Wheels, Steering, Repair Group 40
Repair Manual, Suspension,
Wheels, Steering, Repair Group 40
- Drive new seal in onto stop, do
not tilt seal when doing this.
- Fill space between sealing lip and
dust lip with grease G 052 128
A1.
- Insert flanged shaft.
- Secure flanged shaft with
countersunk bolt and tighten to
specified torque
Page 39-13
item 16 .
- Install axle shaft.
- Connect ball joint to control arm
using new bolts at old impression
marks
- Install wheel.
- Check transmission oil
Page
34-54
.
- Install sound insulation tray.
Oil seals for flanged shafts, replacing
39-7
Differential,
disassembling
and
assembling
Special tools and
equipment
VW 353
Transmission
support
VW 401 Thrust
plate
VW 402 Thrust
plate
VW 407 Press tool
VW 408 A Press
tool
VW 412 Press tool
Differential, disassembling and assembling
39-8
Special tools
and
equipment
40-105
Thrust
plate
3005
Press disk
3259 Tube
3296 Tube
3345 Tube
VAG 1332
Torque
wrench or
equivalent
Differential, disassembling and assembling
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст