Volkswagen Golf / Golf GTI / Jetta. Manual — part 1133
94-52
Installing
Install in reverse order of removal.
- Unclip bulb holder from bulb
housing -arrows-.
High-mount brake light
13/2/2005
94-53
High-mount brake light - Jetta
Wagon, removing and installing
The high-mount brake light is installed
in the upper part of the rear window.
Note:
The bulb holder base plate contains
soldered-in light emitting diodes
(LEDs) that are not replaceable. In the
event of LED malfunction, replace
complete bulb holder.
Removing
CAUTION!
Before beginning repairs on the
electrical system:
Switch off all electrical
consumers.
Switch ignition off and remove
ignition key.
- Remove upper and lower rear lid
trim
Repair Manual, Body Interior,
Repair Group 70
- Remove screws -arrows-.
- Disconnect electrical connector.
High-mount brake light
13/2/2005
94-54
- Unclip bulb housing at both short
sides -arrow-.
Installing
Install in reverse order of removal.
- Unclip bulb holder on both long
sides -arrows-.
High-mount brake light
13/2/2005
94-55
Steering column switches
Steering column switches, removing
and installing
CAUTION!
Before beginning repairs on the electrical
system:
Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
Disconnect negative ( - ) battery terminal.
When disconnecting and reconnecting
battery terminals, observe all applicable
Notes and torque specifications, as well as
instructions on performing OBD program
and electrical system function checks as
specified in this Repair Manual
Page 27-
39
.
CAUTION!
Special safety precautions apply to vehicles
equipped with airbags. Refer to Repair
Manual, Body-Interior, Airbag: CAUTIONS
and WARNINGS, Repair Group 69.
Steering column switches
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст