Volkswagen Golf / Golf GTI / Jetta. Manual — part 1128
94-32
- Disconnect electrical connector.
Installing
- Release left-hand positioning
motor -arrow- by turning to left
and right-hand by turning to right.
- Pull positioning shaft ball head
out of locking device on reflector.
- Guide positioning motor
positioning shaft into ball head
mounting -arrow-, hold reflector
base plate up through opening in
headlight when doing this.
- Lock positioning motor in fitting
position by turning.
- Connect electrical connections.
- Install sealing cover.
- Install headlights
Page 94-22
.
- Check headlight adjustment if
necessary
Page 94-33
.
Headlights - Jetta
13/2/2005
94-33
Headlights, adjusting
Special tools, testers and auxiliary items
needed
VAS 5107 Optical headlight aimer
Notes:
Adjust headlights using detailed aiming
procedures and specifications
Repair Manual, Maintenance
Headlights and fog lights are adjusted
simultaneously.
Left headlight (adjustment screws for right
headlight are a mirror image):
To adjust the lateral and height setting, turn the
respective adjuster with a screwdriver.
1 - Lateral adjustment
2 - Height adjustment
Headlights - Jetta
13/2/2005
94-34
Side mounted turn signals
Side mounted turn signals, removing
and installing
Removing:
CAUTION!
Removal of turn signal lense/housing is only
possible in one direction. The side of the
housing equipped with retainer clip is not
obvious in it's installed position. Use care
when removing to prevent damage to retainer
clip or housing.
CAUTION!
Before beginning repairs on the electrical
system:
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Apply suitable tape in area of lamp in order to
protect paintwork.
- Press turn signal with a suitable tool on the
mounting position side -1- carefully in direction
of arrow against the force of the spring clip
on the opposite side and lever out.
- Pull rubber holder with push-fit bulb off bulb
housing.
- Pull push-fit bulb (12 V/5 W) out of housing (do
not turn).
Side mounted turn signals
13/2/2005
94-35
Installing:
- Fit rubber holder with push-fit bulb onto bulb
housing and insert into fender opening.
- Check side turn signal (bulb) function.
Side mounted turn signals
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст