Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 537
– Install the outer race again and the tighten the transmission
housing to the tightening specification.
Tightening Specifications
♦ Transmission housing to clutch housing. Refer to
3
Adjustment Overview
⇒ “3.1 Overview - Adjustment”, page 221
3.1
Overview - Adjustment
Note
When performing repairs on the transmission, readjustment of the
output shaft for 1st to 4th gears, output shaft for 5th/6th gear and
reverse gears or differential is only required if components, which
have a direct influence on transmission adjustment, have been
replaced. Refer to table to avoid any unnecessary adjusting.
Replaced part:
To be adjusted:
Output Shaft, 1st
to 4th Gears. Re‐
fer to
Output shaft, 5th/
6th and reverse
gears. Refer to
Differential
. Refer to
Transmission Housing
x
x
x
Clutch Housing
x
x
x
Output Shaft, 1st to 4th Gears
x
Output Shaft, 5th/6th and Reverse Gears
x
Differential
x
Output shaft tapered roller bearing, 1st to 4th
Gears
x
Output shaft tapered roller bearing, 5th/6th and
Reverse Gears
x
Differential tapered roller bearing
x
4
Special Tools
Special tools and workshop
equipment required
♦ Press Plate - VW402-
♦ Press Piece - Rod -
VW408A-
♦ Press Piece - Multiple Use
- VW412-
♦ Press Piece - 60mm -
VW415A-
♦ Press Piece - Multiple Use
- 40-105-
♦ Press Piece - Multiple Use
- 3005-
♦ Slide Hammer Set -
VW771-
♦ Slide Hammer Set - Hook -
VW 771/37-
♦ Seal Installer - Flange Shaft
- 3305-
♦ Torque Wrench 1331
5-50Nm - VAG1331-
♦ Torque Wrench 1332
40-200Nm - VAG1332-
♦ Shop Crane - Drip Tray -
VAS6208- or Used Oil Col‐
lection and Extraction Unit -
SMN372500-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст