Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 886
– Measure and record the height at all four wheels.
Note
♦
The Setting Device Basic Set - VAS6430/1- must not be
moved on the calibration beam.
♦
The alignment stand must be in the lowest level position for
the next step.
– Rotate the Setting Device Basic Set - VAS6430/1- upward just
enough so that the calibration beam is parallel to the center of
the measuring sensors on the front wheels, so that it is possi‐
ble to correctly measure the distance measuring unit -1-.
1 - Distance measuring unit with spring tape measure and
mounting pin
– Position the Setting Device Basic Set - VAS6430/1- at a dis‐
tance -a- of 1,500 mm ± 25 mm (59 ± 0.98 in) from the center
of the wheel hub on the front wheels to the beam on the Setting
Device Basic Set - VAS6430/1- .
Caution
♦ Distance -a- 1,500 mm ± 25 mm (59 ± 0.98 in) must be
measured on both side of the vehicle and then the Setting
Device Basic Set - VAS6430/1- must be aligned.
♦ Distance -a- must be the same on both sides of the vehi‐
cle.
– Mount the front wheel measuring sensors -1- to the Setting
Device Basic Set - VAS6430/1- .
– Determine the height value -a- between the Setting Device
Basic Set - VAS6430/1- contact area and the wheel contact
surface on the vehicle alignment platform. Enter it in the align‐
ment computer.
– Loosen the clamping bolt -arrow- and place the measuring bar
-1- on the floor.
– Turn the crank -1- to adjust the Calibration Board For Lane
Guard System - VAS6430/4- to the height specification -2- and
then make a note of it.
If the specified height was reached, then the measuring bar -1-
must be pushed slightly forward and secured with the locking bolt
-arrow-.
– Slide the Setting Device Basic Set - VAS6430/1- to the side
-arrows B-, until the display in the wheel alignment computer
is in the tolerance range.
– By gently turning the adjustment screws -2 and 3-, the Setting
Device Basic Set - VAS6430/1- is secured from rolling away.
– Turn the precision adjustment screw -1- until the display on
the wheel alignment computer is located within the tolerance
range.
– Level the bubble level -A- using the adjusting screw -1-.
– Level the bubble level -B- using the adjusting screws
-2 and 3-.
– Loosen the clamping bolt -arrow- and place the measuring bar
-1- on the floor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст