Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 843
3
Subframe
⇒ “3.1 Overview - Subframe”, page 157
⇒ “3.2 Subframe, Securing”, page 158
⇒ “3.3 Subframe, Servicing”, page 165
3.1
Overview - Subframe
⇒ “3.1.1 Overview - Subframe, Multi-Link Suspension”,
page 157
⇒ “3.1.2 Overview - Subframe, Multi-Link Suspension, AWD”,
3.1.1
Overview - Subframe, Multi-Link Suspension
1 - Subframe
❑ Subframe with attach‐
ments, removing and in‐
stalling. Refer to
2 - Bolt
❑ 70 Nm + 180°
❑ Replace after removal
3 - Bolt
❑ 50 Nm + 45°
❑ Replace after removal
4 - Bolt
❑ 70 Nm + 180°
❑ Replace after removal
3.1.2
Overview - Subframe, Multi-Link Suspension, AWD
1 - Subframe
❑ Subframe with attach‐
ments, removing and in‐
stalling. Refer to
.
2 - Rear Bonded Rubber Bush‐
ing
❑ Replacing. Refer to
3 - Front Bonded Rubber
Bushing
❑ Replacing. Refer to
4 - Bolt
❑ 70 Nm +180°
❑ Replace after removal
3.2
Subframe, Securing
⇒ “3.2.1 Subframe, Securing, Multi-Link Suspension, FWD”, page
158
⇒ “3.2.2 Subframe, Securing, Multi-Link Suspension, AWD”, page
3.2.1
Subframe, Securing, Multi-Link Suspen‐
sion, FWD
Special tools and workshop equipment required
♦ Locating Pins - T10096-
♦ Engine and Gearbox Jack - VAS6931-
♦ Rear Axle Support - T10552-
-T10552- , Preparing
– Loosen the bolts -arrows- and adjust the dimension -a-.
a - 250 mm
Tighten the bolts -arrows-.
– Loosen the bolt -arrow- for the -T10552/2- -2-.
– Turn the -T10552/2- -2- so that the profile is perpendicular to
the direction of travel.
– Adjust the dimension -b-.
b - 330 mm
Tighten the bolt -arrow- to 30 Nm.
– Loosen the -T10552/1- -3- on both sides at the bottom.
– Adjust the dimension -c-.
c - 47 mm
– Turn the -T10552/1- -3- on both sides until the dimension -d-
is set.
d - 230 mm
– Place the -T10552- -1- on the -VAG1383A- or -VAS6931- .
– Tighten the bolt -arrow- to 30 Nm.
– Position the -T10552- -1- with the -VAG1383A- or -VAS6931-
-5- under the rear axle and move it upward.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст