Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 264
Removing
– Remove the rear door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel,
Removing and Installing .
– Lift the inner window shaft strip -1- evenly off of the flange
-2- without bending it.
Installing
– Attach the inner window shaft strip -1- and push it evenly in
direction of -a arrows- onto the rear door flange -2- by hand.
2.17
Outer Cover, Removing and Installing
Note
Removal and installation is described only for the left outer cover. Removing and installing right outer cover is
identical.
Removing
– Remove the rear door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel,
Removing and Installing .
– Remove the door inner cover. Refer to
– Release the outer exterior cover retaining tabs -1- alternating
from side to side with a screwdriver and at the same time re‐
move the outer exterior cover -1- upward from the door -3-.
– Loosen the inner exterior cover adhesive strip -2- from the
door -3- and remove the inner exterior cover -2- upward from
the door, pay attention to the wires while doing so.
Installing
– Check the inner exterior cover -2- and outer exterior cover
-1- for damage. and if necessary replace.
– Replace the two-sided adhesive tape on the inner exterior
cover -2-.
– Remove the protective film from the two-sided adhesive tape
on the inner exterior cover -2-.
– Push the inner exterior cover -2- until stop in the door -3-, while
doing so pay attention to the wiring guide.
– Push the inner exterior cover -2- with force against the door
inner panel.
– Push the outer exterior door cover -1- until stop in the door and
while doing so engage with the inner exterior cover -2-.
– Install the door inner cover. Refer to
⇒ “2.8 Door Inner Cover, Removing and Installing”,
– Install the front door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel, Re‐
moving and Installing .
3
Special Tools
Special tools and workshop
equipment required
♦ Wrench - Door Adjusting -
3320-
♦ Door Adjusting Wrench -
Joint - 3320/1-
♦ Wrench - Door Adjusting -
Box Wrench - 3320/2-
♦ Wrench - Door Adjusting -
Box Wrench - 3320/3-
♦ Torque Wrench 1331
5-50Nm - VAG1331-
♦ Cylinder Head Bolt Socket -
3410-
♦ Gauge - Gap Adjustment -
3371-
♦ Trim Removal Wedge -
3409-
♦ Wedge Set - T10383-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст