Volkswagen Touareg (2003 year). Manual — part 10
aside slightly.
– First unscrew bolt -1- from oil filter housing. Then unscrew
bolts -2- from cover for toothed belt tensioning element.
– Remove cover.
Note
♦
The toothed belt tensioning element is provided with oil damp‐
ing. It can therefore only be pushed back slowly.
♦
Use locking pin -T40011- for securing the tensioning element.
– If necessary, before tensioning align holes in housing and in
piston of tensioning element using long nose pliers or thin wire.
– Turn tensioning lever of toothed belt tensioning roller -1- in
-direction of arrow- using hexagon key.
– Secure tensioning element with locking pin -T40011- when the
tensioning lever of the toothed belt tensioning element -2- has
been pushed back so that the holes in the housing and the
pistons align.
– Insert camshaft clamp -T40005- into camshaft securing plates
and loosen securing bolts by approx. 5 turns.
– Remove camshaft clamp -T40005- again.
Touareg 2003 ➤
1. Cylinder head
37
arm puller -T40001- and hook -T40001/2- .
– Loosen tensioning roller -arrow- and remove toothed belt.
1.4.2
Installing and tensioning
– Note marking for direction of rotation when reinstalling the ex‐
isting toothed belt.
– First, fit toothed belt to crankshaft toothed belt pulley -1-, then
to idler roller of toothed belt tensioner -2- and then to tension‐
ing roller -3-. After that, fit toothed belt to camshaft sprockets
and coolant pump pulley as shown in the illustration.
Note
It should just be possible to turn the camshaft sprockets on the
camshaft tapers.
– Fit camshaft clamp -T40005- onto camshaft pulleys again.
Touareg 2003 ➤
38
tensioning element piston -arrow-.
– Now pre-tension tensioning roller (still in loosened condition)
using torque wrench -V.A.G 1410- with attached reversible
ratchet -VAS 5122- and tensioner wrench -T40009- in anti-
clockwise direction -arrow- to 4 Nm.
– Tighten bolt -1- to 45 Nm in this position.
– Then remove 5 mm drill.
– Turn tensioning lever of toothed belt tensioning roller -1- in
-direction of arrow- using hexagon key.
– When piston of toothed belt tensioning element -2- has been
pushed back by tensioning lever, pull out locking pin -
T40011- .
– Turn tensioning lever of toothed belt tensioning roller -1- in
direction of -arrow-, using hexagon key and place a 7 mm drill
between housing and tensioning lever.
– Tighten camshaft sprockets to 55 Nm.
– Remove camshaft clamp -T40005- again.
– Pull out drill inserted between housing and tensioning lever.
Touareg 2003 ➤
1. Cylinder head
39
-arrow- and tighten to 30 Nm.
– Turn crankshaft two full turns in direction of engine rotation
and check setting dimension -a-: specification 5 mm.
Further assembly is basically the reverse of the dismantling se‐
quence.
1.5
Removing and installing left cylinder
head
.
Touareg 2003 ➤
40
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст