Volkswagen Golf Variant, Jetta. Manual — part 19
Information about gearboxes with different output shafts
⇒ page 73
Vehicles with petrol engines
1.4 l/90 kW TFSI engine and 1.4 l/118 kW TSI engine
⇒ page 74
1.6 l/75 kW MPI engine
⇒ page 81
Vehicles with diesel engine
1.9 l/77 kW TDI PD engine
⇒ page 90
1.6 l/77 kW TDI CR engine
⇒ page 97
4.1
Information about gearboxes with differ‐
ent output shafts
Gearbox with different output shafts.
A - Stub shafts “to 11.2008”
B - Flange shafts “from 12.2008”
Vehicles with stub shafts on gearbox
To remove gearboxes with stub shafts, it is necessary to remove
stub shafts. Only shafts with straight joints can be put back onto
the output shafts safely. Therefore, these drive shafts must be
removed.
Vehicles with flange shafts on gearbox
For gearboxes with flange shafts, the drive shafts must be unbol‐
ted from the gearbox. This way, the gearbox can be removed. In
individual cases, it is necessary to remove right-hand flange shaft
from gearbox. This gives you enough clearance for removing
gearbox.
Secure both drive shafts to suspension struts using tensioning
straps -T10038- .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
4. Removing and installing gearbox
73
TSI engine
Special tools and workshop
equipment required
♦ Support bracket -10 - 222
A-
♦ Adjustment plate -3282/59-
♦ Adapter -10 - 222 A /8-
♦ Insert tool, 18 mm -T10179-
♦ Gearbox support -3282-
♦ Socket -T10061-
♦ Engine and gearbox jack -V.A.G 1383 A-
Brief description
The gearbox is removed downwards separately, without engine.
The battery, air filter and starter are removed “from above”.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
74
height.
– Move selector lever to position “P” position.
Only in vehicles with stub shafts
Note
After loosening centre bolt, do not lower vehicle to ground again.
– Step on the brake pedal while a 2nd mechanic loosens the two
drive shaft bolts -arrow-.
and installing air filter .
Removing and installing battery .
starter .
– Remove securing clip in -direction of arrow-.
Securing clips for selector lever cable must always be renewed.
– Remove Bowden cable from ball head.
Cable may also be pushed slightly backwards out of cable support
bracket and removed later when gearbox is lowered. But then
observe cable when lowering gearbox.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
4. Removing and installing gearbox
75
– Now remove all upper connecting bolts between engine and
gearbox.
These tools are appropriate for this.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
76
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст