Volkswagen Fox (2004 year). Manual — part 37
Page
– Brake fluid: replace
♦ for Europe on vehicles model ▸2007 and except Europe on vehicles model ▸2008
3 years after the delivery inspection; then, every 2 years
Supplementary services
Page
– Headlights: adjust the beams
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
– Poly-V belt: check condition: In vehicles without automatic tensioning element, adjust
tension.
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
– Mechanical transmission: check oil level.
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
– Brake fluid: replace
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
– Carry out an exhaust gas inspection/additional work with separate payment!
♦ in function of the country's legislation
– Sunroof: check operation, clean the guide rails and lubricate them with Special
grease -G 000 450 02-
♦ for vehicles with kilometers traveled over 60,000 km, within a 3-year period and, then,
every 2 years.
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
– Body and paintwork: check for damage.
♦ for vehicles with kilometers traveled over 60,000 km, within a 3-year period and, then,
every 2 years.
♦ for Europe in model 2008▸ vehicle and in model 2009▸ vehicles elsewhere
At every 4 years
Supplementary services
Page
– Air cleaner: replace the filtering element and clean the filter case.
♦ identification letters BAH and BLH
♦ for vehicles with kilometers traveled over 60,000 km, within a 4-year period.
– Air cleaner: replace the filtering element and clean the filter case.
♦ Engine identification letters ASY, BKR, BNM, and BMD.
♦ for vehicles with kilometers traveled over 60,000 km, within a 4-year period.
– Spark plugs: replace
♦ for vehicles with kilometers traveled over 60,000 km, within a 4-year period.
♦ Checking data, spark plugs ⇒ Ignition system; Rep. Gr. 28 ; Ignition system
FOX 2004 ➤
2. Service plans
21
General remarks
3.1
Rear license plate (only CrossFox Eu‐
rope) - install
Note
For the “CrossFox”Europe versions, position the license plate
aligned with the line -1- in the rear protector and fasten the plate
-2- to this position
3.2
Lifting the vehicle with a workshop lift
and jack
WARNING
♦ Before positioning the vehicle onto a lift, it is necessary to
make sure that there is enough space between the lift and
the lower body parts.
♦ The vehicle may only be lifted in the support points indi‐
cated in illustration, in order to avoid damaging the vehicle
floor and prevent the vehicle from tipping.
♦ Never start the engine and engage a gear with the vehicle
lifted, even if only one drive wheel is on the floor. If these
guidelines are not followed, there will be risk of an acci‐
dent!
♦ When it is necessary to work under the vehicle, it must be
supported onto appropriate stands.
♦ Before placing a vehicle on an lift, make sure that the ve‐
hicle weight does not exceed the authorized load capacity
of the lift.
♦ To prevent damage, always use a suitable rubber or
wooden support.
♦ Under no circumstances must the vehicle be lifted by the
oil crankcase, transmission, front or rear axles.
♦ The vehicle must not be lifted by the vertical reinforcement
of the longitudinal member.
FOX 2004 ➤
22
3. General remarks
Support points for workshop lift and jack
Front section: In the longitudinal reinforcement of the central lon‐
gitudinal member.
Rear section: In the welded flange reinforcement of the lower lon‐
gitudinal member.
Note
To anchor the CrossFox, using electrical-hydraulic lifts, refer to
the Tools and Equipment Manual.
3.3
Service tag
3.3.1
Stick the tag “Next service” (upon Deliv‐
ery inspection)
– Write on the service tag the date of the next service (including
brake fluid change) and attach the tag to the left side of the
command panel or to the left door pillar (B).
The stamp or tag may also be attached to the left lower corner
(internal side) of the Windscreen, with the “FRONT” facing outside
the vehicle (check instructions in the Service Organization Man‐
ual).
3.3.2
Stick the tag “Next service” (upon Oil
Change Service or Inspection Service)
– On the service tag “Next service”: Mark the Oil Change Service
or Inspection Service (whichever occurs first) and write down
the date and mileage traveled.
FOX 2004 ➤
3. General remarks
23
driver's door pillar (pillar B).
The stamp or tag may also be attached to the left lower corner
(internal side) of the Windscreen, with the “FRONT” facing outside
the vehicle (check instructions in the Service Organization Man‐
ual).
3.3.3
Paste the “data holder” on the customer
service plan (in the delivery inspection):
– Please paste the upper data holder on both -arrow-.
1 - planning week.
2 - PR number.
3.4
Self-diagnosis - refer to the fault memo‐
ry of all systems
3.4.1
Refer to the fault memory of all systems
with the Diagnosis, Measurement and
Information System
Special tools and workshop equipment required
♦ Diagnosis, Measurement and Information System
♦ Diagnosis cable -VAS 5051/3- or - VAS 5051/6-
FOX 2004 ➤
24
3. General remarks
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст