Volkswagen Jetta / Jetta Hybrid. Manual — part 25
2.9.3
Installing
Carry out following work:
– Pull door handle -2- off door in direction of -arrow a-.
– Push cover cap -1- into bearing bracket -arrow b- at a right
angle.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Door components
97
– Fit cover -5-.
2.10
Removing and installing door handle
Note
Removal and installation are described only for the right door
handle. The removal and installation of the left door handle are
similar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
98
Carry out following work:
– Remove lock cylinder
⇒ page 93
or cover cap
⇒ page 95
.
– Pull door handle -1- towards rear slightly -arrow a- until it
comes out of mounting of bearing bracket.
– Swivel door handle in direction of -arrow b-.
– Remove door handle from bearing bracket at a right angle
-arrow c-.
– Pull connector (if there is one) off door handle -1-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Door components
99
Carry out following work:
– Connect connector (if there is one) to door handle -1-.
– Seat door handle -1- in bearing bracket, whereby handle must
be at right angles to door -arrow a-.
– Swing door handle -1- into door - arrow b-.
– Slide door handle forcibly forwards -arrow c- into mounting of
bearing bracket.
– Install lock cylinder
⇒ page 93
or cover cap
⇒ page 95
.
• It is essential that a functional check is then performed with
the door open.
2.11
Removing and installing door lock
Note
Removal and installation are described only for the right door lock.
The removal and installation of the left door lock is similar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
100
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст