Kia Carnival (2009+). Instruction — part 319

2009 > G 2.7 DOHC >

REPLACEMENT

1. Remove the automatic transaxle assembly.

2. Remove the valve body cover(refer to the overhaul manual).

3. Disconnect the oil temperature sensor connector.

4. Remove the oil temperature sensor(B), loosening the mounting bolt(A).

5. Replace the sensor with the new one and reassemble the rest of the parts.

INSPECTION

1. Remove the oil temperature sensor(A).

2. Measure the resistance between the terminal 1 and 2 of the sensor connector.

Temp.[°C(°F)]

Resistance(K!)

0(32)

100(212)

18.6
0.63

3. If the value is out of the specfication, replace the oil temperature sensor.

Automatic Transaxle System

Automatic Transaxle Control System -

Inhibiter Switch

Automatic Transaxle System

2009 > G 2.7 DOHC >

DESCRIPTION

Inhibitor Switch

- Type: Rotary contact type
- Range of temperature : -40°C~145°C(-40°F~293°F)

Inhibitor Switch - Continuity check(Sports mode)

2009 > G 2.7 DOHC >

REPLACEMENT

1. Pull up the parking brake.

2. Position the shift lever in 'N' range.

3. Remove the air cleaner assembly.

4. Remove the battery.

5. Remove the battery tray.

6. Remove the inhibiter switch connector.

7. Remove the shift cable mounting nut(A).

8. Remove the inhibiter switch loosening the mounting bolts.

9. Refering to 'INSPECTION', check for continuity. If there is an error, replace the inhibiter switch.

10. After tightening the shift cable mounting nut, connect the inhibiter switch.

11. Install the battery, battery tray and the air cleaner assembly.

INSPECTION

1. Check for the starter motor when the ignition switch is at 'START' position and the shift lever at 'P' or 'N' range.

2. Check for the rear lamp when the ignition switch if it does not work properly.

3. Check for the inhibiter switch if it does not work properly.

4. If the inhibiter switch is not fixed in a proper position, reassemble it in the right position.

5. Re-check 1 and 2 procedures.

6. Using a scan tool, confirm the DTCs.

7. Disconnect the battery (-) terminal and the inhibiter switch.

8. Check for continuity between terminals at the switch connector.