Kia Carnival (2009+). Instruction — part 559
Heating, Ventilation, Air Condi-
tioning
Rear Heater - Rear Temperature Control
Actuator
Heating, Ventilation, Air Conditioning
2009 > G 2.7 DOHC >
DESCRIPTION
1. Heater unit includes mode control actuator and temperature control actuator.
2. Temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
Signal from control unit adjusts position of temperature door by operating temperature switch and then temperature
will be regulated by the hot/cold air ratio decided by position of temperature door.
2009 > G 2.7 DOHC >
INSPECTION
1. Ignition "OFF".
2. Disconnect the connector of temperature control actuator.
3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 1 and
grounding terminal 2.
Verify that the temperature control actuator operates to the cool position when connecting in the reverse.
4. Check the voltage between terminals 3 and 4.
Specification
Door position
Voltage (3-4)
Error detecting
Max. cooling
0.4 ± 0.15V
Low voltage : 0.1V or less
Max. heating
4.6 ± 0.15V
High voltage : 4.9V or more
* It will feedback current position of actuator to controls.
5. If the measured voltage is not specification, substitute with a known-good temperature control actuator and check
for proper operation.
6. If the problem is corrected, replace the temperature control actuator.
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the luggage side trim (Refer to BD-).
3. Remove the rear heater unit (Refer to HA-).
4. Disconnect the temperature control actuator connector after removing the air duct.
5. Loosen the mounting screw and then remove the temperature control actuator (A).
6. Installation is the reverse order of removal.
Heating, Ventilation, Air Condi-
tioning
Rear Heater - Rear Mode Control Actuator
Heating, Ventilation, Air Conditioning
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст