Kia Carnival (2009+). Instruction — part 560
2009 > G 2.7 DOHC >
INSPECTION
1. Ignition "OFF".
2. Disconnect the connector of mode control actuator.
3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 1 and
grounding terminal 2.
4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
5. Check the voltage between terminals 3 and 4.
Door position
Voltage (3-4)
Error detecting
Vent
0.4 ± 0.15V
Low voltage :0.1V or less
Defrost
4.6 ± 0.15V
High voltage :4.9V or more
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the rear heater unit.
3. Disconnect the mode control actuator connector (A).
4. Loosen the mounting screws and then remove the mode control actuator (B).
5. Installation is the reverse order of removal.
Heating, Ventilation, Air Condi-
tioning
Rear Heater - Rear Power Mosfet
Heating, Ventilation, Air Conditioning
2009 > G 2.7 DOHC >
INSPECTION
1. Ignition "ON".
2. Manually operate the control switch and measure the voltage of blower motor between pin 1 and 2.
3. Select the control switch to raise voltage until high speed.
Fan
Voltage
Manual
1 STEP
4.5 ± 0.5V
2 STEP
5.7 ± 0.5V
3 STEP
6.9 ± 0.5V
4 STEP
8.1 ± 0.5V
5 STEP
9.3 ± 0.5V
6 STEP
10.3 ± 0.5V
7 STEP
Battary(+)
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the luggage side trim (Refer to BD-).
3. Disconnect the power mosfet connector (A).
4. Remove the power mosfet (B) after loosening the mounting screws.
Heating, Ventilation, Air Condi-
tioning
Rear Heater - Rear Control Panel
Heating, Ventilation, Air Conditioning
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст