Kia Carnival (2009+). Instruction — part 273
Clutch System
Clutch System - Clutch Cover and Dinode
Clutch System
2009 > G 2.7 DOHC >
COMPONENTS
2009 > G 2.7 DOHC >
REPLACEMENT
1. Remove a transaxle assembly (refer to 'MT'-group).
2. Remove the clutch cover bolts. Not to be bent or twisted, loosen them in diagonal directions.
3. Remove the clutch cover and disc.
4. Using the SST(09411-43000), install a clutch disc and cover.
• Replace a clutch cover and disc as a set.
* Possible problems when not following the caution
- When replacing only a disc, slip problem can occur because of the initial clamp load loss by the adjusting
ring's unusual work.
- When replacing only a disc, it can be difficult to cut power because the thickness of the disc cannot be
permitted.
• Apply grease on a disc spline part and transmission input shaft spline part as required.
* Possible problems when not following
- When not applying: Excessively wear of splines and bad clutch operation
- When excessively applying: Scattered grease by centrifugal force conteminates the clutch disc. Loss of
friction force can cause a slip
• The 'T/M SIDE' marked surface should face the transaxle.
! If the surface face the opposite side, there can be an interference between a disc and a flywheel surface.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст