Kia Carnival (2009+). Instruction — part 126
2009 > G 3.8 DOHC >
SPECIFICATION
IGNITION SYSTEM
Items
Specification( 3.8L)
Ignition coil
Primary resistance
0.62 ± 10 % (!)
Secondary resistance
7.0 ± 15 % (k!)
Spark plugs
Unleaded
NGK
IFR5G-11
Gap
1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)
STARTING SYSTEM
Items
Specification
3.8L
Starter
Rated voltage
12 V, 1.4 kW
No. of pinion teeth
8
No-load
characteristics
Voltage
11.5 V
Ampere
85A, MAX
Speed
2,600 rpm, MIN
CHARGING SYSTEM
Items
Specification
/ 3.8L
Alternator
Type
Battery voltage sensing
Rate voltagea
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC regulator built-in type
Regulator setting voltage
14.2 ~ 14.8V
Temperature compensation
-4 ± 4 mV / °C
Battery
Type
MF 68AH(3.3L) / MF 80AH(3.8L)
Cold cranking amperage [at -18°C(-0.4°F)]
600 A(3.3L) / 630 A(3.8L)
Reserve capacity
110 min(3.3L) / 130 min(3.8L)
Specific gravity [at 20°C(68°F)]
1.280 ± 0.01
- COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal
voltage of 7.2V or greater at a specified temperature.
- RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal
voltage of 10.5V at 26.7°C(80.1°F).
AUTO CRUISE CONTROL SYSTEM
Items
Specification
Setting error
Within ± 1.5Km/h on level road
Vehicle speed memory variation
No variation
Setting time
0.1sec max
Resuming time
0.1sec max.
Minimum operating speed
40 ± 2Km/h
Cancel speed range
15 ± 2Km/h
Maximum memorized speed
160 ± 2Km/h
Pulling force
127N(13Kgf)
Main switch serial resistance value
3.9k! ± 1%
Command switch serial resistance value
SET switch : 220! ± 1%
RESUME switch : 910! ± 1%
2009 > G 3.8 DOHC >
TROUBLE SHOOTING
IGNITION SYSTEM
Symptom
Suspect area
Remedy
Engine will not start or
is hard to start
(Cranks OK)
Ignition lock switch
Ignition coil
Spark plugs
Ignition wiring disconnected or broken
Inspect ignition lock switch, or replace as required
Inspect ignition coil, or replace as required
Inspect spark plugs, or replace as required
Repair wiring, or replace as required
Rough idle or stalls
Ignition wiring
Ignition coil
Repair wiring, or replace as required
Inspect ignition coil, or replace as required
Engine hesitates/poor
acceleration
Spark plugs and spark plug cables
Ignition wiring
Inspect spark plugs / cable, or replace as required
Repair wiring, or replace as required
Poor mileage
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
CHARGING SYSTEM
Symptom
Suspect area
Remedy
Charging warning
indicator does not
light with ignition
switch "ON" and
engine off.
Fuse blown
Light burned out
Wiring connection loose
Electronic voltage regulator
Check fuses
Replace light
Tighten loose connection
Replace voltage regulator
Charging warning
indicator does not go
out with engine
running. (Battery
requires frequent
recharging)
Drive belt loose or worn
Battery cable loose, corroded or worn
Electronic voltage regulator or alternator
Wiring
Adjust belt tension or replace belt
Inspect cable connection, repair or replace
cable
Replace voltage regulator or alternator
Repair or replace wiring
Overcharge
Electronic voltage regulator
Voltage sensing wire
Replace voltage regulator
Repair or replace wiring
Discharge
Drive belt loose or worn
Wiring connection loose or short circuit
Electronic voltage regulator or alternator
Poor grounding
Worn battery
Adjust belt tension or replace belt
Inspect wiring connection, repair or replace
wiring
Replace voltage regulator or alternator
Inspect ground or repair
Replace battery
STARTING SYSTEM
Symptom
Suspect area
Remedy
Engine will not crank
Battery charge low
Battery cables loose, corroded or worn out
Transaxle range switch (Vehicle with automatic
transaxle only)
Fuse blown
Starter motor faulty
Ignition switch faulty
Charge or replace battery
Repair or replace cables
Refer to TR group-automatic transaxle
Replace fuse
Replace
Replace
Engine cranks slowly
Battery charge low
Battery cables loose, corroded or worn out
Starter motor faulty
Charge or replace battery
Repair or replace cables
Replace
Starter keeps running Starter motor
Ignition switch
Replace
Replace
Ignition switch
Replace
Starter spins but
engine will not crank
Short in wiring
Pinion gear teeth broken or starter motor
Ring gear teeth broken
Repair wiring
Replace
Replace fly wheel or torque converter
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст