Kia Carnival (2007 year). Instruction — part 421

21. Install the air conditioning compressor bracket (A).

Tightening torque :
BOLT (B):
38.2 ~ 58.8Nm (3.9 ~ 6.0kgf.m, 28.2 ~ 43.4lb-ft)
BOLT (C):
18.6 ~ 27.5Nm (1.9 ~ 2.8kgf.m, 13.7 ~ 20.3lb-ft)

22. Install the generator mounting bracket (A) and the power steering pump bracket (B).

Tightening torque :
BOLT (C):
38.2 ~ 58.8Nm (3.9 ~ 6.0kgf.m, 28.2 ~ 43.4lb-ft)
BOLT (D):
34.3 ~ 53.9Nm (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)
BOLT (E):
68.6 ~ 93.2Nm (7.0 ~ 9.5kgf.m, 50.6 ~ 68.7lb-ft)

23. Install the drive belt auto-tensioner (A).

Tightening torque :
15.7 ~ 22.6Nm (1.6 ~ 2.3kgf.m, 11.6 ~ 16.6lb-ft)

24. Install the oil cooler assembly (A) and the knock sensor (B).

Tightening torque :
Oil cooler bolts:
15.7 ~ 22.6Nm (1.6 ~ 2.3kgf.m, 11.6 ~ 16.6lb-ft)
Knock sensor bolts:
14.7 ~ 24.5Nm (1.5 ~ 2.5kgf.m, 10.8 ~ 18.1lb-ft

25. Install the air separator (A) and hose (B).

Tightening torque :
15.7 ~ 22.6Nm (1.6 ~ 2.3kgf.m, 11.6 ~ 16.6lb-ft)

26. Install the water pump, cylinder head and timing belt in order.

27. Remove the engine stand.

Cooling system

2007 > J2.9L DIESEL CRDI(VGT) >

ENGINE COOLANT REFILLING AND BLEEDING

When pouring engine coolant, be sure to shut the relay box lid and not to let coolant spill on the electrical parts of
the paint. If any coolant spills, rinse it off immediately.

1. Slide the heater temperature control lever to maximum heat. Make sure the engine and radiator are cool to the

touch.

2. Remove the radiator cap(A).

3. Loosen the drain plug(A), and drain the coolant.

4. Tighten the radiator drain plug securely.

5. Remove the coolant reservoir tank. Drain the coolant and reinstall the coolant reservoir tank. Fill the coolant

reservoir tank to the MAX mark with the coolant.

6. Mix the recommended antifreeze with an equal amount of water in a clean container.

a. Use only genuine antifreeze/coolant.
b. For best corrosion protection, the coolant concentration must be maintained year-round at 50% minimum.

Coolant concentrations less than 50% may not provide sufficient protection against corrosion of freezing.

c. Coolant concentrations greater then 60% will impair cooling efficiency and are not recommended.

a. Do not mix different brands of antifreeze/coolants.
b. Do not use additional rust inhibitors or antirust products; they may not be compatible with the coolant.

7. Pour the coolant into the radiator to the base of the filler neck, and install the radiator cap loosely.