Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 973
8C–2
ENTERTAINMENT
Cigarette Lighter
General Description
When the cigarette lighter is pushed in with the starter
switch at either “ACC” or “ON” position, a circuit is formed
in the cigarette lighter case to heat the lighter coil.
The cigarette lighter is sprung back to its original position
after the lighter coil is heated.
Removal
1. Disconnect the battery ground cable.
2. Remove the lower cluster assembly(1).
Refer to the Instrument Panel Assembly removal
steps in Body Structure section.
3. Disconnect the connectors, remove the socket of the
illumination light, the retaining ring(7), the outer
case(6), the cigarette lighter(3) and socket(4), the
bezel(5) and then remove the cigarette lighter
assembly(2).
826RS007
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. When installing the bezel, align the projected portion
of the socket with the notch of the bezel.
ENTERTAINMENT
8C–3
Digital Clock and Outside Temp
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly(1).
Refer to the Instrument Panel Assembly in Body
Structure section.
3. Remove the lower cluster assembly(2).
Refer to the Instrument Panel Assembly in Body
Structure section.
4. Remove the instrument panel driver lower cover
assembly(3).
Refer to the Instrument Panel Assembly in Body
Structure section.
740R200050
5. Remove the instrument panel cluster assembly(4).
Refer to the Instrument Panel Assembly in Body
Structure section.
6. Disconnect the connector and push the lock from the
back side of the instrument panel cluster assembly to
remove the digital clock and outside temp (5).
821R200035
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Push in the switch with your fingers until it locks
securely.
8C–4
ENTERTAINMENT
Front ACC Socket
Removal
1. Disconnect the battery ground cable.
2. Remove the front cover assembly (1).
Refer to the “Instrument Panel Assembly” in the Body
Structure section of this manual.
3. Disconnect the connectors (2).
4. Twist the ACC cover (3) counterclockwise to remove
it together with the ACC socket (4).
826R200029
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. The projection portion socket is united with Bezel
cutting and lacking, and is attached.
Rear ACC Socket
Removal
1. Disconnect the battery ground cable.
2. Remove two screws and disconnect the connector to
remove the ACC socket (1).
810RW311
Installation
To install, follow the removal steps in the reverse order.
ENTERTAINMENT
8C–5
Rod Type Antenna
Removal
1. Disconnect the battery ground cable.
2. Turn the antenna rod(1) counterclockwise to remove
it.
3. Remove three screws and nine clips to remove the
fender inner liner(2).
4. Disconnect the feeder cable connector at the inside of
the vehicle, remove the housing bracket screw, turn
the lock nut counterclockwise to remove it together
with the base mold and then remove the housing(3).
890RS004
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст