Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1674
EXTERIOR/INTERIOR TRIM
8J–3
Consoles
Consoles and Associated Parts
745R200007
EndOFCallout
Removal
1. Disconnect the battery ground cable.
2. Remove the shift knob (M/T) / transfer knob (4
´4).
3. Remove the rear console assembly.
• Open the rear console lid and remove two
screws.
• Disconnect the switch connector.
4. Remove the front console assembly.
• Remove six fixing screws and disconnect the
accessory socket connectors.
Installation
To install, follow the removal steps in the reverse order.
Legend
(1) Front Console
(2) Console Brackets
(3) Rear Console Assembly
8J–4
EXTERIOR/INTERIOR TRIM
Front Door Trim Panel
Front Door Trim Panel and Associated Parts
635R100001
EndOFCallout
Legend
(1) Glass Run
(2) Glass
(3) Window Regulator/Power Window Regulator
(4) Outer Waste Seal
(5) Outside Handle
(6) Door Lock Cylinder
(7) Door Lock Assembly/Door Lock Actuator
(8) Waterproof Sheet
(9) Door Trim Panel
(10) Courtesy Light Lens
(11) Speaker Grill
(12) Grip Cover
(13) Inside Handle
(14) Power Window Switch/Window Regulator
Handle
(15) Speaker Assembly
(16) Tweeter
(17) Door Mirror Cover
(18) Door Mirror Assembly
EXTERIOR/INTERIOR TRIM
8J–5
Removal
1. Disconnect the battery ground cable.
2. Remove the door mirror assembly.
• Refer to Door Mirror Assembly in this section.
3. Remove the regulator handle (1).
• Pull the hook (2) out and remove the regulator
handle.
631RW004
4. Remove the power window switch (1).
• Pry the power window switch out and disconnect
the switch connector.
825RW097
5. Remove the speaker cover.
6. Remove the front speaker.
• Remove the front speaker fixing screws in order
to disconnect the speaker connector.
7. Remove the inside handle fixing screw.
CAUTION: Do not apply excessive force on the
inside handle link or damage may occur, which
could make the inside handle difficult to operate.
632RW003
8. Remove the door trim panel.
• Remove 5 fixing screws (1), (3) in order to take
off 6 clips (2) from the door panel.
635RW007
• Disconnect the tweeter and courtesy light
connectors to lift the door trim panel and unlock
the engagement of the waist seal section. Then,
pass the inside handle through the mounting hole
of the trim panel, and detach the trim panel.
9. Remove the inside handle.
10. Remove the tweeter.
Installation
To install, follow the removal steps in the reverse order.
8J–6
EXTERIOR/INTERIOR TRIM
Rear Door Trim Panel
Rear Door Trim Panel and Associated Parts
655R100001
EndOFCallout
Legend
(1) Glass Run
(2) Glass
(3) Fix Window Glass
(4) Window Regulator/Power Window Regulator
(5) Outside Handle
(6) Door Lock Assembly
(7) Speaker Bracket
(8) Speaker
(9) Bracket
(10) Rear Door Corner Garnish
(11) Door Trim Panel
(12) Power Window Switch and Pull Case/Window
Regulator Handle
(13) Inside Handle
(14) Waterproof Sheet
(15) Outer Waste Seal
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст