Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1617
LIGHTING SYSTEM
8A–11
High Mounted Stoplight Assembly (Soft Top Model)
Removal
1. Disconnect the battery ground cable.
2. Remove the high mounted stoplight assembly (2).
D
Remove the cover (3).
D
Disconnect the connector (1).
D
Remove two screws.
803RW001–1
Installation
To install, follow the removal steps in the reverse order.
High Mounted Stoplight Bulb (Soft Top Model)
Removal
1. Disconnect the battery ground cable.
2. Remove the cover (1).
3. Remove the bulb (2).
D
Pull out the bulb from the socket (3).
803RW002–1
Installation
To install, follow the removal steps in the reverse order.
8A–12
LIGHTING SYSTEM
High Mounted Stoplight Assembly (Resin Top Model)
Removal
1. Disconnect the battery ground cable.
2. Remove the high mounted stoplight assembly (1).
D
Remove the two screws.
D
Pull out the high mounted stoplight assembly (1).
D
Disconnect the connector.
803RW012
Installation
To install, follow the removal steps in the reverse order.
High Mounted Stoplight Bulb (Resin Top Model)
Removal
1. Disconnect the battery ground cable.
2. Remove the cover (3).
3. Disconnect the connector (1).
4. Remove the bulb (2).
803RX002
Installation
To install, follow the removal steps in the reverse order.
LIGHTING SYSTEM
8A–13
Backup Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the rear combination light assembly.
D
Refer to the Taillight Bulb removal step 2 in this
section.
3. Remove the bulb (1).
D
Remove the backup light socket by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
825RW073
Installation
To install, follow the removal steps in the reverse order.
Front Turn Signal Light Bulb
Removal and Installation
Refer to Side Marker Light Bulb in this section.
8A–14
LIGHTING SYSTEM
Rear Turn Signal Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the rear combination light assembly.
D
Refer to the Taillight Bulb removal step in this
section.
3. Remove the bulb (1).
D
Remove the rear turn signal light socket by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
825RW074
Installation
To install, follow the removal steps in the reverse order.
Dome Light Bulb (LWB)
Removal
1. Disconnect the battery ground cable.
2. Remove the lens (2).
3. Remove the bulb (1).
D
Pull out the bulb.
825RW075
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст