Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1626
8C–4
ENTERTAINMENT
Accessory Socket
Front Accessory Socket
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly.
3. Remove the front accessory socket (2).
• Disconnect the connectors (1).
• Pull out the front accessory socket from the soket
cover (3).
810RW005
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
Rear Accessory Socket
Removal
1. Disconnect the battery ground cable.
2. Remove the quarter trim lower cover.
3. Remove the rear accessory socket (2).
• Disconnect the connectors (1).
• Pull out the front accessory socket from the soket
cover (3).
810RW004
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
ENTERTAINMENT
8C–5
Radio
Removal
1. Disconnect the battery ground cable.
2. Remove the lower cluster assembly (1).
• Refer to Instrument Panel Assembly in Body
Structure section.
890RW022
3. Remove the radio (2).
• Remove the two fixing screws.
• Disconnect the connector (4) and the antenna
cable (3).
890R100017
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
8C–6
ENTERTAINMENT
Amplifier
Removal
1. Disconnect the battery ground cable.
2. Remove the amplifier (2) from the dash panel (4).
• Remove the two fixing nuts (3).
• Disconnect the connector (6).
3. Remove the Amplifier (2) from the BRKT (5).
• Remove the four fixing screws (1).
890R200044
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
ENTERTAINMENT
8C–7
Speaker
Front Speaker
Removal
1. Disconnect the battery ground cable.
2. Pull the grille (1) to release the locks and then
remove it.
3. Remove four screws and disconnect the connector
(3) to remove the speaker (2).
890RX012
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
Tweeter Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the front door trim pad (2).
• Refer to Front Window Regulator, Glass And
Glass Run in Body Structure section:
3. Remove the tweeter (1).
• Disconnect the connector.
635R100004
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
Rear Door Speaker (LWB)
Removal
1. Disconnect the battery ground cable.
2. Remove the inside handle (3).
3. Remove the rear door trim pad (2).
• Refer to Rear Window Regulator, Glass And
Glass Run in Body Structure Section:
4. Remove the rear speaker (1).
• Disconnect the connector.
890R100015
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст