Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1625
WIPER/WASHER SYSTEM
8B–17
Main Data and Specifications
Torque Specifications
Application
N·m
Lb Ft
Lb In
Windshield Wiper Motor Shaft Nut
14
—
122
Windshield Wiper Arm Nuts
23
17
—
Rear Wiper Motor Shaft Nut (Resin Top Model)
7
—
61
Rear Wiper Arm Nut (Resin Top Model)
11
—
95
Rear Wiper Motor Shaft Nut (LWB)
12
—
104
Rear Wiper Arm Nut (LWB)
16
12
—
ENTERTAINMENT
8C–1
RODEO
BODY AND ACCESSORIES
CONTENTS
ENTERTAINMENT
Service Precaution. . . . . . . . . . . . . . . . . . . . .
8C–1
Cigarette Lighter . . . . . . . . . . . . . . . . . . . . . .
8C–2
General Description . . . . . . . . . . . . . . . . . .
8C–2
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–2
Installation . . . . . . . . . . . . . . . . . . . . . . . . .
8C–2
Digital Clock. . . . . . . . . . . . . . . . . . . . . . . . . .
8C–2
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–2
Installation . . . . . . . . . . . . . . . . . . . . . . . .
8C–2
Rod Type Antenna. . . . . . . . . . . . . . . . . . . . .
8C–3
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–3
Installation . . . . . . . . . . . . . . . . . . . . . . . . .
8C–3
Accessory Socket . . . . . . . . . . . . . . . . . . . . .
8C–4
Front Accessory Socket . . . . . . . . . . . . . . .
8C–4
Rear Accessory Socket . . . . . . . . . . . . . .
8C–4
Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–5
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–5
Installation. . . . . . . . . . . . . . . . . . . . . . . . . .
8C–5
Amplifier. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–6
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–6
Installation. . . . . . . . . . . . . . . . . . . . . . . . . .
8C–6
Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–7
Front Speaker . . . . . . . . . . . . . . . . . . . . . . .
8C–7
Tweeter Assembly . . . . . . . . . . . . . . . . . . .
8C–7
Rear Door Speaker (LWB) . . . . . . . . . . . . .
8C–7
Rear Speaker (LWB) . . . . . . . . . . . . . . . . .
8C–8
Rear Speaker (SWB) . . . . . . . . . . . . . . . . .
8C–8
Horn . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–9
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .
8C–9
Installation. . . . . . . . . . . . . . . . . . . . . . . . . .
8C–9
Service Precaution
WARNING: THIS VEHICLE HAS A SUPPLEMENTAL
RESTRAINT SYSTEM (SRS). REFER TO THE SRS
COMPONENT AND WIRING LOCATION VIEW IN
ORDER TO DETERMINE WHETHER YOU ARE
PERFORMING SERVICE ON OR NEAR THE SRS
COMPONENTS OR THE SRS WIRING. WHEN YOU
ARE PERFORMING SERVICE ON OR NEAR THE
SRS COMPONENTS OR THE SRS WIRING, REFER
TO THE SRS SERVICE INFORMATION. FAILURE TO
FOLLOW WARNINGS COULD RESULT IN POSSIBLE
AIR BAG DEPLOYMENT, PERSONAL INJURY, OR
OTHERWISE UNNEEDED SRS SYSTEM REPAIRS.
CAUTION: Always use the correct fastener in the
proper location. When you replace a fastener, use
ONLY the exact part number for that application.
ISUZU will call out those fasteners that require a
replacement after removal. ISUZU will also call out
the fasteners that require thread lockers or thread
sealant. UNLESS OTHERWISE SPECIFIED, do not
use supplemental coatings (Paints, greases, or
other corrosion inhibitors) on threaded fasteners or
fasteners joint interfaces. Generally, such coatings
adversely affect the fastener torque and the joint
clamping force, and may damage the fasteners.
When you install fasteners, use the correct
tightening sequence and specifications. Following
these instructions can help you avoid damage to
parts and systems.
8C–2
ENTERTAINMENT
Cigarette Lighter
General Description
When the cigarette lighter is pushed in with the starter
switch at either “ACC" or “ON" position, a circuit is
formed in the cigarette lighter case to heat the lighter
coil.
The cigarette lighter springs back to its original position
after the lighter coil is heated.
Removal
1. Disconnect the battery ground cable.
2. Remove the lower cluster assembly (1).
• Refer to the Instrument Panel Assembly in Body
Structure section.
3. Remove the cigarette lighter assembly (2).
• Disconnect the connectors.
• Remove the socket (3).
826RW004-1
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1. When installing the bezel, align the projected portion
of the socket with the notch of the bezel.
Digital Clock
Removal
1. Disconnect the battery ground cable.
2. Remove the dash side trim panel-LH (1).
Refer to Instrument Panel Assembly in Body
Structure section.
3. Remove the lower cover assembly (2).
Refer to instrument Panel Assembly in Body
Structure section.
821RW254-1
4. Remove the meter cluster assembly (4).
Refer to Instrument Panel Assembly in Body
Structure section.
5. Remove the digital clock (3).
• Remove the fixing screw.
• Disconnect the connector.
821RW092-1
Installation
To install, follow the removal steps in the reverse order.
ENTERTAINMENT
8C–3
Rod Type Antenna
Removal
1. Disconnect the battery ground cable.
2. Turn the antenna rod (1) counterclockwise to
remove it.
3. Remove three screws and nine clips to remove the
fender inner liner (2).
4. Disconnect the feeder cable connector (3) at the
inside of the vehicle, remove the housing bracket
screw, turn the lock nut counterclockwise to remove
it together with the base mold and then remove the
housing.
890RW020
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст