Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 455
ENTERTAINMENT
8C–5
Audio
Removal
1. Disconnect the battery ground cable.
2. Remove the center cluster assembly (1).
D
Refer to
Instrument Panel Assembly in Body
Structure section.
890R200032
3. Remove the audio (2).
D
Remove the two fixing screws (3).
D
Disconnect the connector and the antenna cable.
890R200033
Installation
To install, follow the removal steps in the reverse order.
8C–6
ENTERTAINMENT
Speaker
Front Speaker
Removal
1. Disconnect the battery ground cable.
2. Remove the front door trim pad.
D
Refer to
Front Door in Body Structure section.
3. Remove the front speaker (2).
D
Remove the three screws and the speaker spacer
(1).
D
Disconnect the connector (3).
890R200028
Installation
To install, follow the removal steps in the reverse order.
Front Tweeter Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the front door trim pad (2).
D
Refer to
Front Door in Body Structure section.
3. Remove the tweeter (1).
D
Disconnect the connector.
890R200030
Installation
To install, follow the removal steps in the reverse order.
Rear Door Speaker
Removal
1. Disconnect the battery ground cable.
2. Remove the rear door trim pad.
D
Refer to
Rear Door in Body Structure section.
3. Remove the rear speaker (2).
D
Remove the three screws and the speaker spacer
(1).
D
Disconnect the connector (3).
890R200028
ENTERTAINMENT
8C–7
Installation
To install, follow the removal steps in the reverse order.
Rear Tweeter Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the rear door trim pad (2).
D
Refer to
Rear Door in Body Structure section.
3. Remove the tweeter (1).
D
Disconnect the connector.
890R200031
Installation
To install, follow the removal steps in the reverse order.
8C–8
ENTERTAINMENT
Horn
Removal
1. Disconnect the battery ground cable.
2. Remove the horn.
D
Disconnect the connector.
D
Remove the horn mounting bolt.
NOTE: High (1), Low (2)
828R200003
Installation
To install, follow the removal steps in the reverse order.
Display (MID)
Removal
1. Disconnect the battery ground cable.
2. Remove the cluster upper cover.
D
Disconnect the sun sensor connector and the GPS
control unit connector.
3. Remove the center cluster.
D
Refer to
Instrument Panel Assembly in Body
Structure.
4. Remove the Display (1).
D
Remove the screws (2).
D
Disconnect the Display connector and MID control
unit connector.
890R200036
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст