Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1551
7A–44
AUTOMATIC TRANSMISSION (4L30–E)
2. Pull the black plastic piece toward the
connector. Hold the piece near the connector.
Pull the connector from the fuel pipe.
If the connector and fuel pipe are stuck
together, jiggle the connector back and forth to
loosen the connector. Do not yank the
connector from the fuel pipe.
141RY00002
141RY00003
3. Tie a vinyl bag around the connector and fuel
pipe to protect them from dirt.
141RY00004
2. Joining the connector and fuel hose
1. Remove the vinyl bag from the connector and
fuel hose. Check that the contact surfaces are
undamaged and free of dirt and other foreign
material. Clean if necessary.
2. Align the axis of the fuel pipe and connector.
Push the connector into the fuel pipe until a
distinct click is heard.
141RY00005
7A–45
AUTOMATIC TRANSMISSION (4L30–E)
3. Gently pull on the connector to check that it is
securely latched.
141RY00006
8. Disconnect transmission harness connector and clip.
Connector : Adapter case, mode switch, main case,
magnetic sensor, transfer switch (4
×
4), 2–4 actuator
(4
×
4) and car speed sensor.
9. Remove harness heat protector (V6).
815RW002
10. Support transmission with a jack.
Remove rear mount nuts from third crossmember.
(4
×
4)
F07RW008
(4
×
2)
F07R100005
11. Remove third crossmember.
7A–46
AUTOMATIC TRANSMISSION (4L30–E)
12. Disconnect transmission oil cooler pipes from A/T
side.
13. Remove oil pipe clamp and bracket from the
converter housing.
14. Loosen oil cooler pipe clamp bolt at the engine mount
side.
(V6, 4
×
4)
253RY001
(HEC)
253R100001
15. Remove select cable by disconnecting inner cable
from select lever and removing outer cable with
bracket.
256RW025
16. Remove starter (V6).
17. Remove under covers from the transmission and
engine.
(HEC)
240R100005
7A–47
AUTOMATIC TRANSMISSION (4L30–E)
18. Remove transfer control lever fixing bolts and push up
transfer control lever (V6, 4
×
4).
262RW015
19. Remove flex plate torque converter fixing bolts (6
pieces) by turning crankshaft.
(V6)
240RW005
(HEC)
240R100004
20. Remove engine transmission fixing bolts.
21. Remove exhaust pipe bracket from converter
housing and exhaust pipe (HEC).
150R100009
22. Pull out transmission from the engine.
23. Remove the rear mount rubber and propeller
protector assembly if required (4
×
2).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст