Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1552
7A–48
AUTOMATIC TRANSMISSION (4L30–E)
Installation
1. Slowly raise transmission jack until front of the
transmission is aligned with rear of the engine. Attach
the transmission to the engine.
2. Tighten engine transmission bolts as shown in the
figure.
(V6)
F07RY001
7A–49
AUTOMATIC TRANSMISSION (4L30–E)
(HEC)
F07R100006
D
Install exhaust pipe bracket to converter housing
and exhaust pipe (HEC).
150R100009
3. Align the flex plate torque converter bolt boss with flex
plate hole by turning the torque converter. Install flex
plate torque converter bolts (6 pieces) by turning the
crankshaft.
Torque:
54 N
•
m (40 lb ft) (V6)
:
29 N
•
m (22 lb ft) (HEC)
NOTE: Do not reuse the flex plate torque converter bolt.
(V6)
240RW005
7A–50
AUTOMATIC TRANSMISSION (4L30–E)
(HEC)
240R100004
4. Install transfer control lever on the transfer case (V6,
4
×
4).
262RW015
5. Install under covers to the transmission and engine.
(HEC)
240R100005
Torque: 8 N
•
m (69 lb in) (V6 / HEC)
6. Install starter (V6).
Torque: 40 N
•
m (30 lb ft)
7. Install select cable by connecting inner cable to select
lever and installing outer cable with bracket.
256RW025
7A–51
AUTOMATIC TRANSMISSION (4L30–E)
8. Connect transmission oil cooler pipes to A/T.
Torque: 44 N
•
m (33 lb ft)
9. Install oil cooler pipe clamp and bracket to the
converter housing.
(V6, 4
×
4)
253RY001
(HEC)
253R100001
10. Tighten oil cooler pipe clamp bolt at the engine mount
side.
11. Install third crossmember.
Torque: 76 N
•
m (56 lb ft)
12. Install rear mount nuts.
Torque: 50 N
•
m (37 lb ft)
(4
×
4)
F07RW008
(4
×
2)
F07R100005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст