Isuzu N-Series. Service manual — part 90
2-66 CAB AND FRAME
2. Apply the sealant (1) around the seat belt lower an-
chor bolt mounting hole on the floor part (2).
Sealant: TOKIWA CHEMICAL INDUSTRY 770GA or
equivalent
3. Install the seat belt lower anchor (3) in the specified
direction, and tighten it to the specified torque.
Tighten:
Anchor bolt to 44 N
⋅m (4.5 kg⋅m/32.5 lb⋅ft)
Caution:
Install the seat belt lower anchor so that it may not run
on the anchor detent bead.
Fixing Torque
N2A0109E
N2A0110E
N2A0111E
CAB AND FRAME 2-67
Tongue Side Seat Belt (Crew Cab Model)
Component
Removal
1. Seat belt lower anchor bolt
2. Retractor cover
• Remove the 2 fixing screws.
3. Through anchor cover
4. Seat belt upper anchor bolt
5. Retractor fixing bolt
• Remove the bolt and pull the retractor upper
bracket from panel to remove.
6. Adjuster cover
Installation
For installation, refer to “Tongue Side Seat Belt (Single
Cab Model)” in this section, and reverse the removal
procedure.
Legend
1. Seat belt upper anchor bolt
5. Retractor fixing bolt
2. Through anchor cover
6. Bracket
3. Tongue side seat belt assembly
7. Retractor cover
4. Seat belt lower anchor bolt
N2A0238E
2-68 CAB AND FRAME
Fixing Torque
Front Center and Driver’s Side Seat Belt
Buckle
Removal
1. Disconnect the battery ground cable.
2. Fixing bolt (1)
3. Center seat belt buckle (2)
4. Disconnect the seat belt warning connector (4).
5. Driver’s side seat belt buckle (3)
Caution:
For wide cab model, perform the steps 1 and 2 (Center),
or the steps 1, 3 and 4 (Driver’s side).
Installation
For installation, reverse the removal procedure taking
the following points into consideration.
1. Apply the sealant (1) around the fixing bolt mount-
ing hole on the floor part (2).
Sealant: TOKIWA CHEMICAL INDUSTRY 770GA or
equivalent
N2A0111E
N2A0114E
CAB AND FRAME 2-69
2. Install the anchor in the specified direction, and
tighten it to the specified torque.
Tighten:
Fixing bolt to 44 N
⋅m (4.5 kg⋅m/32.5 lb⋅ft)
3. Pass the center seat belt buckle through the band
on the end of seat cushion.
Caution:
Install the anchor so that it may not run on the anchor
detent bead.
Legend
1. Center seat belt buckle (Wide cab model)
2. Center seat belt buckle (Except wide cab
model)
3. Driver’s side seat belt buckle
N2A0115E
N2A0116E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст