Isuzu Trooper (2000 year). Service manual — part 483
8F–79
BODY STRUCTURE
Tailgate Center Weatherstrip
Parts Location
682RS003
Legend
(1) Clip
(2) Tailgate Center Weatherstrip
Removal
1. Remove tailgate center weatherstrip.
D
Remove the fixing clips in order to pull the tailgate
center weatherstrip out from the tailgate panel.
Installation
1. Tailgate center weatherstrip (1).
D
Start assembling at the A portion.
682RW006
D
Clean the tailgate center weatherstrip (4) adhesive
tape (2) and the butyl seal (3) fitting position of the
tailgate panel.
D
Affix new adhesive tape and the butyl seal to the
weatherstrip (lower side) in order to install the
tailgate center weatherstrip to the tailgate panel
with no gap between them.
682RS004
8F–80
BODY STRUCTURE
Tailgate Main Weatherstrip
Parts Location
682RS005
Legend
(1) Tailgate Main Weatherstrip
Removal
1. Remove tailgate main weatherstrip.
D
Pull the tailgate main weatherstrip out from the
body panel.
Installation
1. Tailgate main weatherstrip.
D
Align the A and B positions to the corners of the
body panel. Install the tailgate main weatherstrip to
the body panel by gently tapping with a plastic
hammer. There should be not clearance between
the body panel the tailgate main weatherstrip.
8F–81
BODY STRUCTURE
Spare Tire Carrier
Parts Location
530RS001
Legend
(1) Spare Tire
(2) Spare Tire Carrier
Removal
1. Remove spare tire.
2. Remove spare tire carrier by using spare tire carrier
nut wrench J–34355.
530RS002
Installation
1. Install the spare tire carrier.
D
Tighten the carrier fixing bolts to the specified
torque.
Torque : 31 N
•
m (23 lb ft)
2. Install the spare tire.
D
Tighten the spare tire fixing bolts to the specified
torque.
Torque : 118 N
•
m (87 lb ft)
8F–82
BODY STRUCTURE
Headlining
Parts Location
666RW003
Legend
(1) Clip
(2) Interior Trim Panels
(3) Sun Roof Finisher (W/Sun Roof)
(4) Headlining
(5) Dome Light
(6) Sunvisors
(7) Map Light
(8) Sunvisor Holder
(9) Rear View Mirror
(10) Multi Meter
Removal
1. Disconnect the battery ground cable.
2. Remove interior trim panels.
D
Refer to the Exterior / Interior Trim section.
3. Remove dome light.
D
Remove the dome light lens and the fixing screws.
D
Disconnect the dome light connectors.
4. Remove multi meter (4).
D
Remove two caps (2), two screws (3) and
disconnect the connector (1).
821RW241
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст