Isuzu Trooper (2000 year). Service manual — part 484
8F–83
BODY STRUCTURE
5. Remove rear view mirror.
D
Remove the rubber stopper (1).
D
Pry off the mirror stay cover (2) and remove 3
screws.
720RW004
6. Remove map light/sun roof switch.
D
Pry the map light clip free from the map light/sun
roof switch bracket and disconnect the connector.
805RS001
7. Remove sunvisors.
D
Remove the fixing screw and turn the sunvisor
holder (1) to remove it.
D
Disconnect the vanity mirror illumination connector.
743RS006
8. Remove sun roof finisher (W/Sun roof).
9. Remove headlining.
D
Remove the headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the headlining so that the fixing clips will not
come off.
2. To install the sun roof finisher (3), first fit in at one
place with the head lining (2) close to the sun roof
frame complete (1), then install the entire finisher
tightly by hitting it with a plastic hammer, not allowing
it to move up.
665RS001
8F–84
BODY STRUCTURE
Rear Air Deflector
Parts Location
667RW001
Legend
(1) Rear Roof Trim Cover
(2) Rear Air Deflector
(3) Roof Rail
(4) Rear Inner Roof Rail
(5) Fixing Bolt
(6) Nylon Washer
(7) Rear Outer Roof Panel
(8) Seal
(9) Fixing Nut
(10) Rear Pillar Upper Reinforcement
(11) Rear Outer Roof Rail
(12) Roof Panel
(13) Grommet
Removal
1. Disconnect the battery ground cable
2. Remove rear roof trim cover.
D
Refer to Luggage Side and Quarter Upper Trim
Cover in Exterior / Interior Trim section.
3. Remove rear air deflector.
D
Take notice of the grommet and the nylon washer.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
8F–85
BODY STRUCTURE
1. Install the grommet (1) to the air deflector (2) drain
hole.
667RW002
2. Use a new nylon washer (4). Peel off the adhesive
tape of the washer to install the nylon washer to the air
deflector (3).
667RW004
3. Install the air deflector (2) to the roof by referring to the
specified values shown in the illustration.
667RW003
4. Tighten the deflector fixing to the specified torque.
Bolt Torque : 6 N
•
m (52 lb in)
Nut Torque : 8 N
•
m (69 lb in)
8F–86
BODY STRUCTURE
Roof Moulding
Parts Location
645RX002
Legend
(1) Windshield Side Moulding Upper Clip
(2) Roof Moulding
(3) Roof Moulding Clip
(4) Roof End Moulding
Removal
1. Disconnect the battery ground cable.
2. Remove roof moulding.
3. Remove roof end moulding.
D
Remove the sealing adhesive and the adhesive
tape of the roof end moulding from the panel using a
knife or scraper while you peel them off.
4. Remove roof moulding clip.
D
Remove the clips.
Installation
1. Install the roof moulding clip (1).
D
Install the clips to the specified positions on the roof
panel flange (2).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст