Isuzu Trooper (1998-2002 year). Service manual — part 1040
8F–88
BODY STRUCTURE
Headlining
Parts Location
666RW003
Legend
(1) Clip
(2) Interior Trim Panels
(3) Sun Roof Finisher (W/Sun Roof)
(4) Headlining
(5) Dome Light
(6) Sunvisors
(7) Map Light
(8) Sunvisor Holder
(9) Rear View Mirror
(10) Multi Meter
Removal
1. Disconnect the battery ground cable.
2. Remove interior trim panels.
D
Refer to the Exterior / Interior Trim section.
3. Remove dome light.
D
Remove the dome light lens and the fixing screws.
D
Disconnect the dome light connectors.
4. Remove multi meter (4) (If so equipped).
D
Remove two caps (2), two screws (3) and
disconnect the connector (1).
821RW241
8F–89
BODY STRUCTURE
5. Remove rear view mirror.
D
Remove the rubber stopper (1).
D
Pry off the mirror stay cover (2) and remove 3
screws.
720RW004
6. Remove map light/sun roof switch.
D
Pry the map light clip free from the map light/sun
roof switch bracket and disconnect the connector.
805RS001
7. Remove sunvisors.
D
Remove the fixing screw and turn the sunvisor
holder (1) to remove it.
D
Disconnect the vanity mirror illumination connector.
743RW008
8. Remove sun roof finisher (W/Sun roof).
9. Remove headlining.
D
Remove the headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the headlining so that the fixing clips will not
come off.
2. To install the sun roof finisher (3), first fit in at one
place with the head lining (2) close to the sun roof
frame complete (1), then install the entire finisher
tightly by hitting it with a plastic hammer, not allowing
it to move up.
665RS001
8F–90
BODY STRUCTURE
Rear Air Deflector
Parts Location
667RW001
Legend
(1) Rear Roof Trim Cover
(2) Rear Air Deflector
(3) Roof Rail
(4) Rear Inner Roof Rail
(5) Fixing Bolt
(6) Nylon Washer
(7) Rear Outer Roof Panel
(8) Grommet
(9) Fixing Nut
(10) Rear Pillar Upper Reinforcement
(11) Rear Outer Roof Rail
(12) Roof Panel
(13) Grommet
Removal
1. Disconnect the battery ground cable
2. Remove rear roof trim cover.
D
Refer to Luggage Side and Quarter Upper Trim
Cover in Exterior / Interior section.
3. Remove rear air deflector.
D
Take notice of the grommet and the nylon washer.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
8F–91
BODY STRUCTURE
1. Install the grommet (1) to the air deflector (2) drain
hole.
667RW002
2. Use a new nylon washer (4). Peel off the adhesive
tape of the washer to install the nylon washer to the air
deflector (3).
667RW004
3. Install the air deflector (5) to the roof by referring to the
specified values shown in the illustration.
667RW003
4. Tighten the deflector fixing to the specified torque.
Bolt Torque : 6 N
•
m (0.6kg·m/52 lb in)
Nut Torque : 8 N
•
m (0.8kg·m/69 lb in)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст