Opel Agila (2011 year). Instruction — part 4
54
The portable ashtray can be fitted in
the front or rear cup holder in the
centre console.
Warning lights, gauges
and indicators
Indicates vehicle speed.
Displays the recorded distance.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
55
Odometer display brightness
To change brightness level, switch on
headlights and press the MODE
button repeatedly until the squares
that indicate the brightness level
appear in the odometer display.
⃞⃞⃞⃞ = maximum brightness
⃞
= minimum brightness
Press and hold the MODE button to
cycle through brightness levels.
Displays the recorded distance since
the last reset.
There are two independent trip
odometers which indicate how far the
vehicle has been driven since the last
reset.
Press the MODE button repeatedly
until A or B appears on the left of the
display.
To reset a trip odometer, press and
hold the MODE button for approx.
2 seconds while the relevant trip
odometer is displayed.
Displays the engine speed.
Drive in a low engine speed range for
each gear as much as possible.
If the needle is in the red warning
zone, the maximum permitted
engine speed is exceeded. Engine
at risk.
Displays the fuel level in the tank (F
indicates full, E indicates empty).
-------------------------------------------------------------------------------------------------------------------------------------------------------------
56
Control indicator Y illuminates if the
level in the tank is low. Refuel
immediately.
Never run the tank dry.
Because of the fuel remaining in the
tank, the top-up quantity may be less
than the specified tank capacity.
In the case of vehicles with fixed
engine oil change and service
intervals, InSP appears in the
odometer display if the ignition is
switched on when servicing is
overdue: have the next service
carried out within one week or
500 km. Seek the assistance of
a workshop.
After the service is complete, have
the display reset. Seek the assistance
of a workshop.
The mode or selected gear is shown
in the transmission display.
P
= Automatic transmission
park position
R
= Reverse gear
N
= Neutral
D
= Drive
L, 2, 3 = Selected gear, automatic
transmission
-------------------------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------------------------
58
The control indicators described are
not present in all vehicles. The
description applies to all instrument
versions. When the ignition is
switched on, most control indicators
will illuminate briefly as a functionality
test.
The control indicator colours mean:
red
= danger, important
reminder
yellow = warning, information, fault
green = confirmation of activation
blue
= confirmation of activation
O
flashes green.
Flashes if a turn signal or the hazard
warning flashers are activated.
Rapid flashing: failure of a turn signal
light or associated fuse.
Bulb replacement 3 99.
Fuses 3 103.
Turn signals 3 66.
X
for driver seat illuminates or flashes
red.
Illuminates
After the ignition is switched on until
the seat belt is fastened.
Flashes
If vehicle speed exceeds 15 km/h and
driver seat belt is not fastened, X will
flash for approx. 90 seconds along
with a warning chime.
X
will then illuminate until driver seat
belt is fastened.
Fastening the seat belt 3 31.
v
illuminates red.
When the ignition is switched on, v
flashes several times. If it does not
flash when the ignition is switched on,
stays lit, illuminates or flashes while
driving, there is a fault in the belt
tensioner or the airbag system. The
airbags and belt tensioners may fail to
trigger in the event of an accident.
Deployment of the belt tensioners or
airbags is indicated by continuous
illumination of v.
9 Warning
Have the cause of the fault
remedied immediately by
a workshop.
Belt tensioners, airbag system 3 30,
* for front passenger airbag
illuminates or flashes yellow.
Illuminates
When the front and side airbag
systems for the front passenger seat
have been deactivated.
Flashes
When the ignition is switched on.
Airbag system 3 33, belt tensioners
-------------------------------------------------------------------------------------------------------------------------------------------------------------
59
p
illuminates red.
Illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
Illuminates when the engine is
running
Stop, switch off engine. Battery is not
charging. Engine cooling may be
interrupted. Power to the brake servo
unit may be cut. Seek the assistance
of a workshop.
Z
illuminates yellow.
Illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
Illuminates when the engine is
running
Fault in the emission control system.
The permitted emission limits may be
exceeded. Seek the assistance of
a workshop immediately.
Vehicles with electric throttle
body system
If the battery has been disconnected,
the system must be recalibrated upon
reconnection of the battery. Hold
ignition key in ON position for
5 seconds without running the
engine.
If the procedure is not successful Z
remains illuminated after the engine
is started. Seek the assistance of
a workshop immediately.
R
illuminates red.
Illuminates when the parking brake is
released if the brake fluid level is too
9 Warning
Stop. Do not continue your
journey. Consult a workshop.
Illuminates after the ignition is
switched on if the parking brake is
u
illuminates yellow.
Illuminates briefly after the ignition is
switched on. The system is ready for
operation when the u goes out.
If u does not go out after a few
seconds, or if it illuminates while
driving, there is a fault in the ABS. The
brake system remains operational but
without ABS regulation.
If during driving u illuminates in
conjunction with R, there is a serious
fault in the brake system. Seek the
assistance of a workshop
immediately.
Antilock brake system 3 89.
c
illuminates yellow.
If c does not illuminate when the
ignition is switched on, stays lit or
illuminates during driving, there is
a fault in the power steering system.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
60
The vehicle can be steered but
considerably more force is required.
Contact a workshop.
b
illuminates or flashes yellow.
Illuminates
There is a fault in the system.
Continued driving is possible. Driving
stability, however, may deteriorate
depending on road surface
conditions.
Have the cause of the fault remedied
by a workshop.
Flashes
The system is actively engaged.
Engine output may be reduced and
the vehicle may be braked
automatically to a small degree.
If the vehicle’s battery has been
disconnected and reconnected, the
system is deactivated and b flashes
once per second. Reactivate system
by driving in a straight line at over
15 km/h briefly until flashing ceases.
ESP illuminates yellow.
If it illuminates during driving, there is
a fault with ESP®. The vehicle’s
brake system remains operational
without ESP® regulation. Seek the
assistance of a workshop.
Electronic Stability Program 3 91.
TCSS OFF illuminates yellow.
Illuminates continuously when the
system is deactivated.
Traction control system TCSS
W
illuminates or flashes red.
Illuminates or flashes when the
engine is running if the coolant
temperature is too high.
If engine coolant temperature is
too high, stop vehicle, switch off
engine. Danger to engine. Check
coolant level.
Coolant level 3 97.
If there is sufficient coolant, consult
a workshop.
I
illuminates red.
Illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
61
Illuminates when the engine is
running
Engine lubrication may be
interrupted. This may result in
damage to the engine and/or
locking of the drive wheels.
1. Move out of the flow of traffic as
quickly as possible without
impeding other vehicles.
2. Depress clutch.
3. Select neutral gear, set selector
lever to N.
4. Switch off ignition.
9 Warning
When the engine is off,
considerably more force is needed
to brake and steer.
Do not remove key until vehicle is
stationary, otherwise the steering
wheel lock could engage
unexpectedly.
Check oil level before seeking
assistance of a workshop 3 96.
Y
illuminates yellow.
Illuminates when level in fuel tank is
too low.
Catalytic converter 3 85.
d
illuminates or flashes yellow.
Illuminates
d
illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
Flashes
After the ignition is switched on, there
may be a fault in the immobiliser
system. The engine cannot be
started.
ENG A-STOP illuminates or flashes
yellow / green.
Illuminates
Illuminates green during an
Autostop.
Illuminates yellow when the Stop-
start system has been deactivated.
If ENG A-STOP illuminates yellow
and the Stop-start system has not
been deactivated, there is a fault in
the Stop-start system. Seek the
assistance of a workshop.
Flashes
Flashes green during an auto restart.
Stop-start system 3 82.
P
illuminates blue.
Illuminated when high beam is on and
?
illuminates during driving to
indicate a fault that requires
immediate attention. Seek the
assistance of a workshop as soon as
possible.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
62
Headlight range adjustment 3 65.
>
illuminates green.
Illuminated when the front fog lights
r
illuminates yellow.
Illuminated when the rear fog light is
on 3 66.
h
illuminates red.
Illuminates when a door or the tailgate
is open.
Vehicle messages
When starting the engine or
while driving
■ If the driver's seat belt is not
fastened and vehicle speed
exceeds approx. 15 km/h.
■ When operating the turn signals.
During an Autostop
■ If the driver's seatbelt is unfastened
and driver's side door is opened.
■ A system failure is detected
preventing auto re-start.
■ The bonnet is opened.
■ Gear selector lever is moved to
positions other than neutral without
depressing clutch pedal.
When the vehicle is parked and/
or the driver's door is opened
■ When the key is in the ignition
switch.
■ With exterior lights on (and ignition
key removed).
-------------------------------------------------------------------------------------------------------------------------------------------------------------
63
The functions can be selected by
pressing the MODE button repeatedly
in the instrument cluster.
Press the MODE button to select one
of the functions:
■ Range
■ Average consumption
■ Instantaneous consumption
Range
Range is calculated from current fuel
tank content and current
consumption. The display shows
average values.
After refuelling, the range is updated
automatically after a brief delay.
When the fuel level in the tank is low,
--.- appears in the odometer display.
Additionally the control indicator Y in
the instrument cluster illuminates.
Average consumption
Display of average consumption. The
measurement can be reset at any
time.
To reset, press the MODE button for
a few seconds while the average
consumption is showing in the
display.
The display will show --.- briefly and
the average consumption figure will
update after a brief delay.
Instantaneous consumption
Display of the instantaneous
consumption. Until the vehicle is
moving, --.- appears in the display.
Setting units of measure
You can select which units of
measure are to be used for fuel
consumption figures.
With the vehicle stationary and with
instantaneous consumption showing
in the display, press and hold the
MODE button for a few seconds to
toggle between L/100km and km/L.
Interruption of power supply
If the power supply has been
interrupted or if the battery voltage
has dropped too low, the values
stored in the trip computer will be lost.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
64
Exterior lighting . . . . . . . 64
Interior lighting . . . . . . . . 67
Exterior lighting
Turn light switch:
9
= Headlights
8
= Sidelights
OFF = Off
To switch from low to high beam,
push lever.
To switch to low beam, push lever
again or pull.
To activate the headlight flash, pull
lever.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
65
Instruction headlight range
adjustment
To adapt headlight range to the
vehicle load to prevent dazzling: turn
knurled wheel to required position.
0 = front seats occupied
1 = all seats occupied
2 = all seats occupied and load
compartment laden
1)
2 = driver's seat occupied and load
compartment laden
The asymmetrical headlight beam
extends visibility at the edge of the
road at the passenger side.
However, when driving in countries
where traffic drives on the opposite
side of the road, adjust the headlights
to prevent dazzling.
Have the headlights adjusted by
a workshop.
Daytime running lights increase
visibility of the vehicle during daylight.
When the engine is started, this
system turns on all lights. This is
cancelled when the light control lever
is turned to any position other than
OFF.
The daytime running lights switch off
when the ignition is switched off.
Operated with the ¨ button.
1)
Vehicles with automatic transmission: set to position 1.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
66
lever up
= right indicator
lever down = left indicator
If the lever is moved past the
resistance point, the indicator is
switched on constantly. When the
steering wheel moves back, the
indicator is automatically deactivated.
Switch the indicator off instructionly by
moving the lever to its original
position.
Operated with the > button.
Front fog lights will only operate when
the headlights or sidelights are
switched on.
Turn inner switch to r.
Rear fog light will only operate when
the headlights are switched on.
The reversing lights come on when
the ignition is on and reverse gear is
selected.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
67
Interior lighting
During entry and exit of the vehicle,
the light automatically switches on
and then off after a delay.
Operate switch:
OFF
= always off
DOOR = automatic switching on
and off
ON
= always on
To prevent the battery from
becoming discharged, do not
leave the interior light switch in the
ON position when leaving the
vehicle.
The lighting switches on when
opened.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
68
Introduction . . . . . . . . .. 69
Radio . . . . . . . . . . ... 72
Audio players . . . . . . . ... 75
Phone . . . . . . . . . . .. 76
-------------------------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст