Opel Zafira Tourer (2019 year). Instruction — part 16
246
Vehicle care
Warning label
Meaning of symbols:
● No sparks, naked flames or
smoking.
● Always shield eyes. Explosive
gases can cause blindness or
injury.
● Keep the vehicle battery out of
reach of children.
● The vehicle battery contains
sulphuric acid which could cause
blindness or serious burn
injuries.
● See the Owner's Instruction for
further information.
● Explosive gas may be present in
the vicinity of the vehicle battery.
Diesel fuel system bleeding
If the tank has been run dry, the diesel
fuel system must be bled. Switch on
the ignition three times for
15 seconds at a time. Then crank the
engine for a maximum of
40 seconds. Repeat this process after
no less than five seconds. If the
engine fails to start, seek the
assistance of a workshop.
Wiper blade replacement
Windscreen
Lift the wiper arm until it stays in the
raised position, press button to
disengage the wiper blade and
remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
247
Rear window
Lift wiper arm. Disengage wiper blade
as shown in illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the ignition, operate and check the
lights.
Halogen headlights
Halogen headlights with separate
bulbs for low beam and high beam.
Sidelights and daytime running lights
are designed as LEDs and can not be
changed.
Low beam (1) outer bulb.
High beam (2) inner bulb.
Front turn signal light (3)
-------------------------------------------------------------------------------------------------------------------------------------------------------------
248
Vehicle care
Low beam (1)
1. Rotate cap anticlockwise and
remove it.
2. Rotate the bulb holder
anticlockwise to disengage.
Withdraw the bulb holder from the
reflector housing.
3. Remove the bulb from the plug
connector by pulling.
4. Replace the bulb and connect it to
the plug connector.
5. Insert the bulb holder, engaging
the lugs into the reflector housing
and rotate clockwise to secure.
6. Fit the cap and rotate clockwise.
High beam (2)
1. Rotate cap anticlockwise and
remove it.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
249
2. Withdraw the bulb holder from the
reflector housing.
3. Remove the bulb from the plug
connector by pulling.
4. Replace the bulb and connect it to
the plug connector.
5. Insert and push the bulb holder
into the reflector housing by
setting the lug into position.
6. Fit the cap and rotate clockwise.
Front turn signal (3)
1. Rotate bulb socket anticlockwise
to disengage. Withdraw the bulb
socket from the reflector housing.
2. Remove the bulb from the socket
by turning anticlockwise and
pulling.
3. Replace and insert new bulb into
socket and turn clockwise.
4. Insert the bulb socket into the
reflector housing and turn
clockwise.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and
turn signal lights are designed as
LEDs and can not be changed.
Have lights repaired by a workshop in
case of failure.
Front fog lights
The bulbs are accessible from
beneath the vehicle.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
250
Vehicle care
1. Remove the outer screws of the
cover, as shown in the illustration.
2. Hinge away the cover.
Turn the bulb socket
anticlockwise and remove it from
the reflector housing.
3. Disengage the bulb socket from
the plug connector by pressing
the retaining lug.
4. Remove and replace the bulb
socket with bulb and attach to the
plug connector.
5. Insert the bulb socket into the
reflector housing, turn clockwise
and engage.
6. Mount the cover with the screws.
Tail lights
1. Hinge out the screw cover.
2. Remove the screws, marked by
the arrows.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
251
3. Carefully withdraw the light
assembly from the retaining pins
and remove.
4. Detach the plug connector from
the light assembly.
5. Remove and replace the bulb by
turning the bulb socket.
Turn signal light (1)
Tail lights (2)
Brake light (3)
Tail lights with Light Emitting
Diode (LED) for tail and brake light
Only the turn signal light (1) can
be replaced.
Remove and replace the bulb by
turning the bulb socket.
6. Connect the plug connector to the
light assembly.
7. Fit light assembly onto retaining
pins and mount the light assembly
using the screws.
8. Plug in screw cover.
Reverse lights (4) in the tailgate
1. Open the tailgate and remove the
cover.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
252
Vehicle care
2. Turn the bulb holder anticlockwise
and remove it from the reflector.
3. Remove the bulb from the socket
by pulling.
4. Replace and insert new bulb into
socket.
5. Insert the bulb socket into the
reflector and turn clockwise.
6. Install the cover.
Rear fog light
The bulbs are accessible from
beneath the vehicle.
1. Turn the bulb socket
anticlockwise and remove it from
the reflector.
2. Remove the bulb from the socket
by turning anticlockwise.
3. Replace and insert new bulb into
the socket by turning clockwise.
4. Insert the bulb socket into the
reflector, turn clockwise and
engage.
Bulb check
Switch on the ignition, operate and
check all lights.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
253
Side turn lights
To replace bulb, remove lamp
housing:
1. Slide lamp to its left side and
remove with its right end.
2. Turn bulb holder anticlockwise
and remove from housing.
3. Pull bulb from bulb holder and
replace it.
4. Insert bulb holder and turn
clockwise.
5. Insert left end of the lamp, slide to
the left and insert right end.
Number plate light
1. Insert screwdriver in recess of the
cover, press to the side and
release spring. Remove cover.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
254
Vehicle care
2. Remove the bulb from the socket
by pulling.
3. Replace the bulb and insert it into
the socket.
4. Push the cover into the housing.
Interior lights
Courtesy lights, reading lights
Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Instrument panel
illumination
Have bulbs replaced by a workshop.
Electrical system
Fuses
Data on the replacement fuse must
match the data on the defective fuse.
There are three fuse boxes in the
vehicle, depending on vehicle
version:
● in the front left of the engine
compartment
● in left-hand drive vehicles, in the
interior behind the storage
compartment, or, in right-hand
drive vehicles, behind the
glovebox
● behind a cover on the left side of
the load compartment
Before replacing a fuse, turn off the
respective switch and the ignition.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
255
There are different kinds of fuses in
the vehicle.
Depending on the type of fuse, a
blown fuse can be recognized by its
melted wire. Do not replace the fuse
until the cause of the fault has been
remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.
Fuse extractor
A fuse extractor may be located in the
fuse box in the engine compartment.
Place the fuse extractor on the
various types of fuse from the top or
side, and withdraw fuse.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
256
Vehicle care
Engine compartment fuse
box
The fuse box is in the front left of the
engine compartment.
Disengage the cover and fold it
upwards until it stops. Remove the
cover vertically upwards.
No. Circuit
1
Engine control module
2
Lambda sensor
3
Fuel injection/Ignition system
4
Fuel injection/Ignition system
5
–
6
Exterior mirror heating/Anti-
theft alarm system
7
Fan control/Engine control
module/Transmission control
module
8
Lambda sensor/Engine cooling
9
Rear window sensor
10 Battery sensor
11 Tailgate release
12 Adaptive forward lighting/Auto‐
matic light control
13 ABS
14 Rear window wiper
15 Engine control module
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
257
No. Circuit
16 Starter
17 Transmission control module
18 Heated rear window
19 Front power windows
20 Rear power windows
21 Rear electrical centre (with fuse
box in the load compartment)
Heated front seats (without fuse
box in the load compartment)
22 Left high beam (Halogen)
23 –
24 Right headlight (LED)
25 Left headlight (LED)
26 Front fog lights
27 Diesel fuel heating
28 Stop-start system
29 Electric parking brake
30 ABS
No. Circuit
31 Adaptive cruise control
32 Airbag
33 Adaptive forward lighting/Auto‐
matic light control
34 Exhaust gas recirculation
35 Exterior mirror/Rain sensor
36 Climate control
37 Canister vent solenoid
38 Vacuum pump
39 Central control module
40 Windscreen washer/Rear
window washer system
41 Right high beam (Halogen)
42 Radiator fan
43 Windscreen wiper
44 Windscreen wiper
45 Radiator fan
46 –
No. Circuit
47 Horn
48 Radiator fan
49 Fuel pump
50 Headlamp levelling/Adaptive
forward lighting
51 Air shutter
52 Auxiliary heater/Diesel engine
53 Transmission control module/
Engine control module
54 Vacuum pump/Instrument
panel cluster/Heating ventila‐
tion/Air conditioning system
After having changed defective fuses,
close the fuse box cover and press
until it engages.
If the fuse box cover is not closed
correctly, malfunctions may occur.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
258
Vehicle care
Instrument panel fuse box
In left-hand drive vehicles, the fuse
box is behind the storage
compartment in the instrument panel.
Open the compartment and push it to
the left to unlock. Fold the
compartment down and remove it.
In right-hand drive vehicles, the fuse
box is located behind a cover in the
glovebox. Open the glovebox, then
open the cover and fold it down.
No. Circuit
1
Cruise control/Speed limiter/
Adaptive cruise control/Steering
wheel controls
2
Exterior lights/Body control
module
3
Exterior lights/Body control
module
4
Infotainment system
5
Infotainment system/Instrument
6
Power outlet/Cigarette lighter
7
Power outlet
8
Left low beam/Body control
module
9
Right low beam/Body control
module/Airbag module
10 Door locks/Body control module
11 Interior fan
12 –
13 Sunblind
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
259
No. Circuit
14 Diagnostic connector
15 Airbag
16 Power outlet
17 Air conditioning system
18 Logistics
19 Body control module
20 Body control module
21 Instrument panel cluster/Anti-
theft alarm system
22 Ignition sensor
23 Body control module
24 Body control module
25 Steering wheel heating
26 –
Load compartment fuse box
The fuse box is on the left side of the
load compartment behind a cover.
Remove the cover.
If equipped with tyre repair kit,
remove the complete box.
Fuse assignments
-------------------------------------------------------------------------------------------------------------------------------------------------------------
260
Vehicle care
No. Circuit
1
–
2
Trailer outlet
3
Parking assist
4
Selective catalytic reduction
system
5
–
6
–
7
Power seat
8
–
9
Selective catalytic reduction
system
10 Nitrogen oxide sensor
11 Trailer module/Trailer socket
12 Trailer module
13 Trailer outlet
14 –
15 –
No. Circuit
16 Interior mirror/Rear view
camera
17 Power outlet
18 –
19 –
20 –
21 Heated front seats
22 –
23 –
24 Selective catalytic reduction
system
25 –
26 –
27 –
28 –
29 –
30 –
No. Circuit
31 –
32 Active damping system/Lane
departure warning
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
261
Vehicle tools
Tools
Some tools, the towing eye and (only
on vehicles with spare wheel) the
vehicle jacking equipment are placed
in the rear storage in the load
compartment floor.
Open the cover in front of the tailgate.
Wheels and tyres
Tyre condition, wheel condition
Drive over edges slowly and at right
angles if possible. Driving over sharp
edges can cause tyre and wheel
damage. Do not trap tyres on the kerb
when parking.
Regularly check the wheels for
damage. Seek the assistance of a
workshop in the event of damage or
unusual wear.
Winter tyres
Winter tyres improve driving safety at
temperatures below 7 °C and should
therefore be fitted on all wheels.
All tyre sizes are permitted as winter
tyres 3 297.
In accordance with country-specific
regulations, affix the speed sticker in
the driver's field of view.
Tyre designations
E.g. 215/60 R 16 95 H
215 : tyre width, mm
60 : cross-section ratio (tyre height
to tyre width), %
R
: belt type: Radial
RF : type: RunFlat
16 : wheel diameter, inches
95 : load index e.g. 95 is equivalent
to 690 kg
H
: speed code letter
Speed code letter:
Q : up to 160 km/h
S : up to 180 km/h
T : up to 190 km/h
H : up to 210 km/h
V : up to 240 km/h
W : up to 270 km/h
Choose a tyre appropriate for the
maximum speed of your vehicle.
The maximum speed is achievable at
kerb weight with driver (75 kg) plus
125 kg payload. Optional equipment
could reduce the maximum speed of
the vehicle.
Performance 3 293.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст