Opel Frontera UBS. Service manual — part 809
8F–64
BODY STRUCTURE
4. Remove glass.
D
Bring the glass down to the position where the bolt
can be seen.
D
Remove the sash division 2 fixing bolts (1) and then
remove the glass fixing bolt to remove the glass
upwards.
651RS003
651RW010
5. Remove window regulator.
D
Disconnect the regulator motor connector (4) and
remove the window regulator cable fixing clip (3)
from the door panel, if model is equipped with power
windows.
D
Remove the window regulator 7 fixing bolts (2) and
pull the regulator out from the lower hole of the door
panel.
651RW011
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the window regulator and the glass fixing
bolts to the specified torque.
Torque : 8 N
•
m (0.8kg·m/69 lb in)
2. Install the waterproof sheet with no clearance
between the door panel and the waterproof sheet.
8F–65
BODY STRUCTURE
Rear Door Fixed Glass And Glass Run
Parts Location
651RW019
Legend
(1) Glass Run
(2) Rear Fixed Glass
(3) Sash Division
(4) Sash Division Fixing Bolts
(5) Door Trim Panel
(6) Waterproof Sheet
(7) Glass
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
3. Remove waterproof sheet.
4. Remove glass.
D
Refer to Window Regulator and Glass removal
procedure in this section.
5. Remove glass run.
D
Pull the glass run (1) out from the door frame.
651RS007
8F–66
BODY STRUCTURE
6. Remove sash division (2).
651RS008
7. Remove door fixed glass.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply soap and water to the fixed glass.
2. Apply soap and water to the door groove and insert
the glass run (3) to the frame from the corner in the
arrow-marked directions.
3. Be sure to install the glass run with its end pointed to
the inside of the vehicle.
A10RW019
8F–67
BODY STRUCTURE
Front Door Sash Moulding
Parts Location
645RS001
Legend
(1) Front Door Sash Moulding
Removal
1. Remove front door slash moulding.
D
To avoid the weatherstrip (1) and pry the door sash
moulding (2) out from the door panel.
645RS002
Installation
1. Install the front door sash moulding.
D
Assemble the edge portion (A portion) of the
moulding so that the clearance between the
moulding and the waist seal becomes 1 mm (0.04
in).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст