Opel Frontera UBS. Service manual — part 810
8F–68
BODY STRUCTURE
Rear Door Moulding
Parts Location
645RS003
Legend
(1) Rear Door Side Moulding
(2) Rear Door Corner Moulding
(3) Rear Door Upper Moulding
Removal
1. Disconnect the battery ground cable.
2. Remove rear door side moulding.
3. Remove rear door upper moulding.
4. Remove rear door corner moulding.
D
Avoiding the weatherstrip (3), pry the moulding (2)
out from the door frame (1).
645RS004
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install each moulding with no clearance between
each piece of moulding.
2. Assemble the edge portion (A portion) of the
moulding so that the clearance between the rear side
moulding and the waist seal is 1 mm (0.04 in).
8F–69
BODY STRUCTURE
Front Door Waist Seal
Parts Location
631RS009
Legend
(1) Nylon Washer
(2) Door Mirror
(3) Front Door Waist Seal
Removal
1. Disconnect the battery ground cable.
2. Remove door mirror.
D
Refer to Exterior / Interrior Trim in this section.
3. Remove front door waist seal.
D
Remove the fixing screw and pull out the waist seal
(1) from the door frame while prying it up.
631RS010
Installation
1. Install the front door waist seal.
D
Apply soap and water to the inside of the waist seal
and align the screw hole of the waist seal to the door
panel hole, and gently tap the seal with a rubber
hammer.
Be sure not to tap the seal hard. This may result in
deforming the seal.
2. Install the door mirror.
8F–70
BODY STRUCTURE
Rear Door Waist Seal
Parts Location
651RW013
Legend
(1) Rear Door Waist Seal
Removal and Installation
Refer to Front Door Waist Seal in this section.
8F–71
BODY STRUCTURE
Front Door Weatherstrip
Parts Location
631RS008
Legend
(1) Check Arm Pin
(2) Bracket
(3) Weather Strip
(4) Clip
Removal
1. Remove check arm pin.
2. Remove front door weatherstrip.
D
Pull the weatherstrip (1) out from the door frame.
631RS011
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст