Opel Frontera UBS. Service manual — part 27
1A – 24 HEATING AND VENTILATION
Removal Steps
1. Center console assembly
2. Lower cluster assembly
3. Glove box
4. Instrument panel passenger lower
cover assembly
5. Instrument panel driver lower cover
assembly
6. Meter cluster assembly
7. Attaching screws
8. Fan switch and air conditioning switch
connector
9. Control lever assembly
10. Control cable
CONTROL LEVER ASSEMBLY AND/OR CONTROL CABLES
6
1
5
2
10
7
7
8
8
9
10
To Mode control link
To Temp control link
To Blower assembly
4
3
Installation Steps
To install, follow the removal steps in
the reverse order.
This illustration is based on LHD
HEATING AND VENTILATION 1A – 25
REMOVAL
Preparation:
Disconnect the battery ground cable
1. Front console assembly
2. Lower cluster assembly
3. Glove box
4. Instrument panel passenger lower cover
5. Instrument panel driver lower cover
6. Meter cluster assembly
Refer to Section 10 “BODY” for INSTRUMENT PANEL
ASSEMBLY removal procedure.
7. Attaching Screws
Remove the 4 attaching screws and disconnect the
control lever cables at heater unit and blower
assembly.
8. Fan Switch and A/C Switch Connector
Pull the control lever assembly out and disconnect
the connectors.
9. Control Lever Assembly
10. Control Cable
1A – 26 HEATING AND VENTILATION
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following points:
1. Adjust the control cables
Air source control cable
1) Slide the control lever to the left (“CIRC” position).
2) Connect the control cable at the “CIRC” position of
the link unit of blower assembly and fix it with the
clip.
Temperature control cable
1) Turn the control knob to the left (“MAX COLD”
position).
2) Connect the control cable at the “COLD” position
of the temperature control link of the heater unit
and fix it with the clip.
Air select control cable
1) Turn the control knob to the right (“DEFROST”
position).
2) Connect the control cable at the “DEFROST”
position of the mode control link of the heater unit
and fix it with the clip.
2. Check control cable operation.
AIR SELECTOR CABLE
Air selector knob
VENT
BI-LEVEL
FOOT
DEF/FOOT
DEF
(DEF)
TEMPERATURE CONTROL CABLE
Temperature control knob
COLD
HOT
(MAX
COLD)
AIR SOURCE SELECT CABLE
Air source select lever
(CIRC)
CIRC
FRESH
Clip
HEATING AND VENTILATION 1A – 27
Removal Steps
1. Control lever assembly
2. Bulb socket
3. Illumination bulb
Installation Steps
To install, follow the removal steps in the
reverse order.
CONTROL PANEL ILLUMINATION BULB
2
3
1
REMOVAL
Preparation:
Disconnect the battery ground cable
1. Control Lever Assembly
Refer to “CONTROL LEVER ASSEMBLY” removal
procedure in this section.
2. Bulb Socket
Pull out the socket from the panel by turning it
counterclockwise.
3. Illumination Bulb
Pull the illumination bulb from socket.
INSTALLATION
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст