Nissan Pathfinder (2005 year). Instruction — part 281
INSIDE MIRROR
GW-55
C
D
E
F
G
H
J
K
L
M
A
B
GW
2005 Pathfinder
INSIDE MIRROR
PFP:96321
Wiring Diagram — I/MIRR —
EIS0042E
WITHOUT HOMELINK®
WIWA0529E
GW-56
INSIDE MIRROR
2005 Pathfinder
With Homelink®
WIWA0530E
INSIDE MIRROR
GW-57
C
D
E
F
G
H
J
K
L
M
A
B
GW
2005 Pathfinder
Removal and Installation
EIS0042F
INSIDE MIRROR
1.
Remove inside mirror finisher (if equipped).
2.
Slide the mirror upward to remove.
3.
Disconnect the connector (if equipped).
Installation is in the reverse order of removal.
1.
Inside mirror
2.
Inside mirror finisher
LIIA0277E
GW-58
REAR WINDOW DEFOGGER
2005 Pathfinder
REAR WINDOW DEFOGGER
PFP:25350
Component Parts and Harness Connector Location
EIS0042G
System Description
EIS0042H
The rear window defogger system is controlled by BCM (body control module) and IPDM E/R (intelligent
power distribution module engine room).
The rear window defogger only operates for approximately 15 minutes.
Power is supplied at all times
●
through 15A fuses [No. 43 (with heated mirrors), 46 and 47, located in the IPDM E/R]
●
to rear window defogger relay
●
through 50A fusible link [letter g , located in the fuse block (J/B)]
●
to BCM terminal 70.
With the ignition switch turned to ON or START position, power is supplied
●
through ignition relay
●
to rear window defogger relay (located in the IPDM E/R)
●
through 10A fuse [No. 1, located in the fuse block (J/B)]
●
to BCM terminal 38
●
through 10A fuse [No. 8, located in the fuse block (J/B)]
●
to front air control terminal 6.
Ground is supplied
●
to BCM terminal 67
●
to front air control terminal 20
●
through body grounds M57, M61 and M79
LIIA1719E
REAR WINDOW DEFOGGER
GW-59
C
D
E
F
G
H
J
K
L
M
A
B
GW
2005 Pathfinder
●
to IPDM E/R terminals 38 and 59
●
through body grounds E9, E15 and E24.
When front air control (rear window defogger switch) is turned to ON, ground is supplied
●
to BCM terminal 9
●
through front air control terminal 11
●
through front air control terminal 20
●
through body grounds M57, M61 and M79.
Then rear window defogger switch is illuminated.
Then BCM recognizes that rear window defogger switch is turned to ON.
Then it sends rear window defogger switch signals to IPDM E/R via CAN communication (CAN-H, CAN-L)
(with auto A/C).
When IPDM E/R receives rear window defogger switch signals, ground is supplied
●
to rear window defogger relay (located in the IPDM E/R)
●
through IPDM E/R terminals 38 and 59
●
through body grounds E9, E15 and E24
Then rear window defogger relay is energized.
With power and ground supplied, rear window defogger filaments heat and defog the rear window.
When rear window defogger relay is turned to ON (with heated mirrors), power is supplied
●
through heated mirror relay (located in the IPDM E/R)
●
through IPDM E/R terminal 23
●
to door mirror defogger (LH and RH) terminal 1.
Door mirror defogger (LH and RH) is grounded through body grounds M57, M61 and M79.
With power and ground supplied, rear window defogger filaments heat and defog the rear window and door
mirror defogger filaments heat and defog the mirrors.
CAN Communication System Description
EIS0042I
Refer to
.
GW-60
REAR WINDOW DEFOGGER
2005 Pathfinder
Schematic
EIS0042J
WIWA0531E
REAR WINDOW DEFOGGER
GW-61
C
D
E
F
G
H
J
K
L
M
A
B
GW
2005 Pathfinder
Wiring Diagram — DEF —
EIS0042K
WIWA0532E
GW-62
REAR WINDOW DEFOGGER
2005 Pathfinder
WIWA0533E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст