Nissan Pathfinder (2005 year). Instruction — part 139
COMPASS AND THERMOMETER
DI-29
C
D
E
F
G
H
I
J
L
M
A
B
DI
2005 Pathfinder
WITH HOMELINK® UNIVERSAL TRANSCEIVER
WKWA2049E
DI-30
COMPASS AND THERMOMETER
2005 Pathfinder
Trouble Diagnoses
EKS009NV
PRELIMINARY CHECK FOR THERMOMETER
1.
COOL DOWN CHECK
1.
Turn the ignition switch to the ON position.
2.
Cool down the ambient sensor 2 with water or ice.
Does the indicated temperature drop?
YES
>> GO TO 2.
NO
>> The system is malfunctioning. Refer to
DI-30, "INSPECTION/COMPASS AND THERMOMETER"
.
2.
WARM UP CHECK
1.
Leave the vehicle for 10 minutes.
2.
With the ignition switch in the ON position, disconnect and reconnect the ambient sensor 2 connector.
Does the indicated temperature rise?
YES
>> The system is OK.
NO
>> The system is malfunctioning. Refer to
DI-30, "INSPECTION/COMPASS AND THERMOMETER"
.
INSPECTION/COMPASS AND THERMOMETER
Symptom
Possible causes
Repair order
No display at all
1. 10A fuse.
2. Power circuit.
3. Ground circuit.
4. Auto anti-dazzling inside mirror.
1. Check 10A fuses [No. 19 (with Homelink® universal transceiver)
and 14 located in fuse block (J/B)].
Turn the ignition switch ON and verify that battery positive volt-
age is at terminals 7 and 10 (with Homelink® universal trans-
ceiver) or terminal 7 (without Homelink® universal transceiver)
of auto anti-dazzling inside mirror.
2. Check power circuit for auto anti-dazzling inside mirror.
3. Check ground circuit for auto anti-dazzling inside mirror.
4. Replace auto anti-dazzling inside mirror.
Forward direction indi-
cation slips off the mark
or incorrect.
1. In instruction correction mode (Bar and
display vanish).
2. Zone variation change is not done.
1. Drive the vehicle and turn at an angle of 90
°
.
2. Perform the zone variation change.
Displays wrong tem-
perature when ambient
temperature is between
−
40
°
C (
−
40
°
F) and
55
°
C (130
°
F)
1. Check operation.
2. Ambient sensor 2 circuit.
3. Ambient sensor 2.
4. Auto anti-dazzling inside mirror.
1. Perform preliminary check shown above.
2. Check harness for open or short between ambient sensor 2 and
auto anti-dazzling inside mirror.
3. Replace ambient sensor 2.
4. Replace auto anti-dazzling inside mirror.
Displays SC or OC
1. Ambient sensor 2 circuit.
2. Ambient sensor 2.
3. Auto anti-dazzling inside mirror.
1. Check harness for open or short between ambient sensor 2 and
auto anti-dazzling inside mirror.
2. Replace ambient sensor 2.
3. Replace auto anti-dazzling inside mirror.
COMPASS AND THERMOMETER
DI-31
C
D
E
F
G
H
I
J
L
M
A
B
DI
2005 Pathfinder
Calibration Procedure for Compass
EKS009NW
The difference between magnetic North and geographical North can sometimes be great enough to cause
false compass readings. In order for the compass to operate accurately in a particular zone, it must be cali-
brated using the following procedure.
CORRECTION FUNCTIONS OF COMPASS
The direction display is equipped with automatic correction function.
If the direction is not shown correctly, carry out initial correction.
WKIA3363E
DI-32
COMPASS AND THERMOMETER
2005 Pathfinder
INITIAL CORRECTION PROCEDURE FOR COMPASS
1.
Pushing the mode (N) or COMP switch for about 10 seconds will
enter the initial correction mode. The “CAL” icon will illuminate.
2.
Turn the vehicle slowly in an open, safe place. The compass will
be calibrated once it has tracked 3 complete circles.
NOTE:
In places where the terrestrial magnetism is extremely disturbed, the
initial correction may start automatically.
WKIA3365E
WARNING LAMPS
DI-33
C
D
E
F
G
H
I
J
L
M
A
B
DI
2005 Pathfinder
WARNING LAMPS
PFP:24814
Schematic
EKS009NX
WKWA2050E
DI-34
WARNING LAMPS
2005 Pathfinder
Wiring Diagram — WARN —
EKS009NY
WKWA2051E
WARNING LAMPS
DI-35
C
D
E
F
G
H
I
J
L
M
A
B
DI
2005 Pathfinder
WKWA2052E
DI-36
WARNING LAMPS
2005 Pathfinder
WKWA2053E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст