Nissan X-Trail 32. Instruction — part 1109
GLOW PLUG
EM-333
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
GLOW PLUG
Exploded View
INFOID:0000000010784331
Removal and Installation
INFOID:0000000010784332
REMOVAL
CAUTION:
Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken.
1.
Disconnect harness connector from glow plug.
2.
Remove glow plug.
CAUTION:
• When removing or installing, never use such tools as an air impact wrench.
• Handle it carefully without giving any impact, even after removal.
INSTALLATION
1.
Remove adhered carbon from glow plug installation hole with a reamer.
2.
Install glow plug.
3.
Install in the reverse order of removal, for the rest of parts.
Glow plug
: N·m (kg-m, ft-lb)
E1BIA1207GB
EM-334
< REMOVAL AND INSTALLATION >
[R9M]
VACUUM PUMP
VACUUM PUMP
Exploded View
INFOID:0000000010784333
Removal and Installation
INFOID:0000000010784334
REMOVAL
1.
Remove battery. Refer to
.
2.
Remove air inlet tube 1. Refer to
3.
Disconnect vacuum hoses.
4.
Disconnect fuel hose quick connector
from fuel pump. (Feed
side)
5.
Remove bracket bolt
.
6.
Remove vacuum pump.
Vacuum pump
Gasket
Vacuum hose
To turbocharger boost control sole-
noid valve
To brake booster
To coolant outlet unit regulation sole-
noid valve
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
E1BIA1208GB
: Vacuum pump
JSBIA5488ZZ
VACUUM PUMP
EM-335
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
• Loosen mounting bolts in reverse order as shown in the figure.
INSTALLATION
Note the following, and install in the reverse order of removal.
Vacuum pump
• Tighten mounting bolts in numerical order as shown in the figure.
CAUTION:
Be sure to check that the vacuum pump is in contact with the
cylinder head before tightening the mounting bolts.
E1BIA0614ZZ
E1BIA0614ZZ
EM-336
< REMOVAL AND INSTALLATION >
[R9M]
OIL SEPARATOR
OIL SEPARATOR
Exploded View
INFOID:0000000010784335
Removal and Installation
INFOID:0000000010784336
REMOVAL
1.
Remove engine cover. Refer to
.
2.
Remove PCV hose.
3.
Disconnect harness connector
of fuel injector.
Oil separator
PCV hose
Gasket
Comply with the installation proce-
dure when tightening. Refer to
336, "Removal and Installation"
To turbocharger air inlet pipe
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
JPBIA6952GB
: Vehicle front
JSBIA5489ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст