Nissan Leaf. Instruction — part 675
COWL TOP
EXT-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
COWL TOP
Exploded View
INFOID:0000000010119990
Removal and Installation
INFOID:0000000010119991
COWL TOP COVER
Removal
1. Fully open hood assembly.
2. Remove front wiper arms (LH and RH). Refer to
WW-49, "Removal and Installation"
.
3. Remove front fender cover. Refer to
.
4. Disconnect washer tube joint on cowl top cover right side.
1.
Cowl top cover seal
2.
Cowl top cover
3.
Cowl top cover clip
4.
Cowl top extension
5.
Cowl top insulator
6.
EPT sealer [3.0 mm (0.118 in)]
7.
EPT sealer [20.0 mm (0.787 in)]
: Clip
: Always replace after every disassembly.
JMKIA6446ZZ
EXT-20
< REMOVAL AND INSTALLATION >
COWL TOP
5. Expand center portion of clip that is fixing clip of cowl top cover
and cowl top extension in the upper and lower direction indi-
cated by arrows as shown in the figure, and then pull out clip
toward vehicle front.
6. Pull forward to release cowl top cover from windshield glass.
CAUTION:
When performing the procedure after removing cowl top
cover, cover the lower end of windshield glass with ure-
thane etc to prevent damage to windshield.
7. Remove cowl top cover.
8. Remove the following parts after removing cowl top cover.
• EPT sealer
• Cowl top cover seal
• Washer tube
• Washer nozzles. Refer to
WW-46, "Removal and Installation"
.
Installation
Installation is in the reverse order of removal.
CAUTION:
Always replace cowl top cover EPT sealer on rear of vehicle with a new one when installing old cowl
top cover.
COWL TOP EXTENTION
Removal
1. Remove cowl top cover. Refer to
EXT-19, "Removal and Installation"
.
2. Remove front wiper drive assembly. Refer to
WW-54, "Removal and Installation"
3. Remove cowl top extension mounting bolts, and then cowl top extension.
Installation
Installation is in the reverse order of removal.
When installing the cowl top extension, tighten the bolts in the order
shown.
PIIB2815J
JMKIA3819ZZ
ALKIA3126ZZ
FENDER PROTECTOR
EXT-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FENDER PROTECTOR
FENDER PROTECTOR
FENDER PROTECTOR : Exploded View
INFOID:0000000010119992
FENDER PROTECTOR : Removal and Installation
INFOID:0000000010119993
REMOVAL
1. Remove front fender protector front end fixing bolts (A) and clip
(B).
1.
Fender protector
2.
Grommet
3.
J nut
4.
Wind deflector
: Vehicle front
JMKIA6447ZZ
JMKIA6488ZZ
EXT-22
< REMOVAL AND INSTALLATION >
FENDER PROTECTOR
2. Remove front fender protector fixing screws (A).
3. Remove front fender protector fixing clips, and then remove front fender protector.
INSTALLATION
Install in the reverse order of removal.
JMKIA6489ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст