Nissan Versa Note. Instruction — part 590
MWI
METER SYSTEM
MWI-35
< WIRING DIAGRAM >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
AANIA1758GB
MWI-36
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000009654108
OVERALL SEQUENCE
DETAILED FLOW
1.
CONFIRM SYMPTOM
Confirm symptom or customer complaint.
>> GO TO 2.
2.
SELF-DIAGNOSIS OF COMBINATION METER
Perform self-diagnosis of combination meter. Refer to
MWI-14, "On Board Diagnosis Function"
.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> If self-diagnosis will not start, check power supply and ground circuit of combination meter. Refer
to
MWI-42, "COMBINATION METER : Diagnosis Procedure"
. If power supply and ground circuits
are OK, replace combination meter. Refer to
MWI-54, "Removal and Installation"
.
3.
CHECK COMBINATION METER WITH CONSULT
Select METER/M&A on CONSULT and perform self-diagnosis of combination meter. Refer to
.
Is the inspection result normal?
YES
>> Check symptom. GO TO 4.
NO
>> Refer to
.
4.
CHECK SYSTEM OPERATION
Check the combination meter to verify that the repair has been completed successfully.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> GO TO 1.
AWNIA2458GB
MWI
U1000 CAN COMM CIRCUIT
MWI-37
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DTC/CIRCUIT DIAGNOSIS
U1000 CAN COMM CIRCUIT
DTC Logic
INFOID:0000000009654109
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009654110
1.
CHECK CAN COMMUNICATION
Select SELF-DIAG RESULTS mode for METER/M&A with CONSULT.
>> GO TO LAN system. Refer to
LAN-15, "Trouble Diagnosis Flow Chart"
DTC
Display Item
Malfunction detected condition
Possible malfunction
U1000
CAN COMM CIRC
[U1000]
When combination meter is not receiving CAN communication
signals for 2 seconds or more.
Combination meter
MWI-38
< DTC/CIRCUIT DIAGNOSIS >
U1010 CONTROL UNIT (CAN)
U1010 CONTROL UNIT (CAN)
Description
INFOID:0000000009654111
Initial diagnosis of combination meter.
DTC Logic
INFOID:0000000009654112
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009654113
1.
REPLACE COMBINATION METER
When DTC U1010 is detected, replace combination meter. Refer to
MWI-54, "Removal and Installation"
.
>> Inspection End.
DTC
Display Item
Malfunction detected condition
Possible malfunction
U1010
CONTROL UNIT (CAN)
[U1010]
When detecting error during the initial diagnosis of
the CAN controller of combination meter.
Combination meter
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст