Nissan Almera Tino V10. Instruction — part 182
AT-452
[ALL]
REPAIR FOR COMPONENT PARTS
e.
Set oil strainer, then tighten bolts A , C , D and nuts F to speci-
fied torque.
f.
Tighten bolts e to specified torque.
: 7 - 9 N-m (0.7 - 0.9 kg-m, 61 - 78 in-lb)
SAT083F
: 3.4 - 4.4 N-m (0.35 - 0.45 kg-m, 30 - 39 in-lb)
SAT084FA
REPAIR FOR COMPONENT PARTS
AT-453
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Control Valve Upper Body
ECS009CK
COMPONENTS
Numbers preceding valve springs correspond with those shown in
AT-519, "SERVICE DATA AND SPECIFI-
.
1.
Control valve upper body
2.
Return spring
3.
Overrun clutch reducing valve
4.
Plug
5.
Retainer plate
6.
Torque converter relief valve
7.
Return spring
8.
Retainer plate
9.
Torque converter clutch control valve
10. Return spring
11.
Plug
12. Sleeve
13. Retainer plate
14. 1-2 accumulator valve
15. Return spring
16. Plug
17. Retainer plate
18. Cooler check valve
19. Return spring
20. Plug
21. Retainer plate
22. Retainer plate
23. Return spring
24. Pilot valve
25. Retainer plate
26. Plug
27. 1-2 accumulator piston
28. Return spring
29. 1-2 accumulator retainer plate
30. Retainer plate
31. Plug
32. 1st reducing valve
33. Return spring
34. Retainer plate
35. Return spring
36. 3-2 timing valve
SAT863J
AT-454
[ALL]
REPAIR FOR COMPONENT PARTS
DISASSEMBLY
1.
Remove valves at retainer plates.
●
Do not use a magnetic pick-up tool.
a.
Use a screwdriver to remove retainer plates.
b.
Remove retainer plates while holding spring, plugs or sleeves.
●
Remove plugs slowly to prevent internal parts from jump-
ing out.
c.
Place mating surface of valve body face down, and remove
internal parts.
●
If a valve is hard to remove, place valve body face down
and lightly tap it with a soft hammer.
●
Be careful not to drop or damage valves and sleeves.
SAT321G
SAT135D
SAT138D
SAT137D
REPAIR FOR COMPONENT PARTS
AT-455
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
INSPECTION
Valve Spring
●
Measure free length and outer diameter of each valve spring.
Also check for damage or deformation.
●
Replace valve springs if deformed or fatigued.
Control Valves
●
Check sliding surfaces of valves, sleeves and plugs.
ASSEMBLY
●
Lay control valve body down when installing valves. Do not
stand the control valve body upright.
1.
Lubricate the control valve body and all valves with ATF. Install
control valves by sliding them carefully into their bores.
●
Be careful not to scratch or damage valve body.
●
Wrap a small screwdriver with vinyl tape and use it to insert
the valves into their proper positions.
Inspection standard
:Refer to
DATA AND SPECIFICATIONS
(SDS)"
.
SAT138D
SAT139D
SAT140DA
SAT141D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст