Nissan Almera Tino V10. Instruction — part 181
AT-448
[ALL]
REPAIR FOR COMPONENT PARTS
Fluid Cooler Relief Valve Spring
●
Check springs for damage or deformation.
●
Measure free length and outer diameter.
ASSEMBLY
1.
Install upper, inter and lower body.
a.
Place oil circuit of upper body face up. Install steel balls in their
proper positions.
b.
Install upper separating gasket, upper inter separating gasket
and upper separating plate in order shown in illustration.
●
Always use new gaskets.
c.
Install reamer bolts “F ” from bottom of upper body. Using
reamer bolts as guides, install separating plate and gaskets as a
set.
Inspection standard: Refer to
.
SAT138D
SAT871J
SAT072F
SAT073F
REPAIR FOR COMPONENT PARTS
AT-449
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
d.
Install pilot filter.
e.
Place lower body as shown in illustration (side of inter body face
up). Install steel balls in their proper positions.
f.
Install inter body on upper body using reamer bolts “F”
as
guides.
●
Be careful not to dislocate or drop steel balls.
g.
Install check balls, fluid cooler relief valve springs and T/C pres-
sure holding spring in their proper positions in lower body.
h.
Install lower separating gasket, lower inter separating gasket
and lower separating plate in order shown in illustration.
SAT074F
SAT870J
SAT076F
MCIB9019E
BAT002
AT-450
[ALL]
REPAIR FOR COMPONENT PARTS
i.
Install bolts “E” from bottom of lower body. Using bolts “E” as
guides, install separating plate and gaskets as a set.
j.
Temporarily install support plates on lower body.
k.
Install lower body on inter body using reamer bolts “F”
as
guides and tighten reamer bolts “F” slightly.
2.
Install O-rings to solenoid valves and terminal body.
●
Apply ATF to O-rings.
3.
Install and tighten bolts.
Bolt length, number and location:
F: Reamer bolt and nut
SAT078F
AAT536
SAT317G
Bolt symbol
A
B
C
D
E
F
G
Bolt length “
”
13.5 mm
(0.531 in)
58.0 mm
(2.283 in)
40.0 mm
(1.575 in)
66.0 mm
(2.598 in)
33.0 mm
(1.299 in)
78.0 mm
(3.071 in)
18.0 mm
(0.709 in)
Number of bolts
6
3
6
11
2
2
1
REPAIR FOR COMPONENT PARTS
AT-451
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
a.
Install and tighten bolts B to specified torque.
b.
Install solenoid valve assembly and line pressure solenoid valve
to lower body.
c.
Remove reamer bolts F and set oil strainer on control valve
assembly.
d.
Reinstall reamer bolt F from lower body side.
SAT869J
: 7 - 9 N-m (0.7 - 0.9 kg-m, 61 - 78 in-lb)
SAT081F
SAT316GA
SAT323G
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст