Nissan Almera Tino V10. Instruction — part 281
Front Door Lock
NLBT0010
NBT098
I
For removal of front door finisher, refer to “DOOR TRIM”,
BT-31.
I
Remove sealing screen.
SBT978
OUTSIDE HANDLE ROD ADJUSTMENT
NLBT0010S02
Rotate rod holder so that rod-to-holder clearance is adjusted as
shown in the figure at left.
CAUTION:
Make sure that rod-to-holder clearance is not “0” mm (0 in),
and that rod is not held pressed.
NBT099
REMOVAL
NLBT0010S03
I
For removal of front door finisher, refer to “DOOR TRIM”,
BT-31.
I
Remove sealing screen.
I
For removal of front door glass, refer to “Front Door Glass”,
BT-14.
1.
Remove lower rear sash (unitized with glass run) securing
bolts. Remove lower rear sash from door panel and away from
door lock.
DOOR
Front Door Lock
BT-18
NBT100
2.
Remove inside handle escutcheon A.
3.
Remove screw securing inside handle.
4.
Detach bell crank at lock knob joining area.
5.
Detach inside handle rod on the door lock assembly side.
6.
Slide inside handle backward and remove inside handle.
7.
Remove rod from inside handle.
NBT101
8.
Detach key lock rod and outside handle rod at joining area (on
the outside handle side).
9.
Disconnect door lock actuator connector.
10. Remove screws securing door lock assembly, then remove
door lock assembly.
11. Remove bolts securing outside handle, then remove outside
handle assembly.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
DOOR
Front Door Lock (Cont’d)
BT-19
Rear Door Lock
=NLBT0011
YBT106
I
For removal of rear door finisher, refer to “DOOR TRIM”,
BT-31.
I
Remove sealing screen.
SBT978
OUTSIDE HANDLE ROD ADJUSTMENT
NLBT0011S01
Rotate rod holder so that rod-to-holder clearance is adjusted as
shown in the figure at left.
CAUTION:
Make sure that rod-to-holder clearance is not “0” mm (0 in),
and that rod is not held pressed.
DOOR
Rear Door Lock
BT-20
SBT983
REMOVAL
=NLBT0011S02
I
For removal of rear door finisher, refer to “DOOR TRIM”,
BT-31.
I
Remove sealing screen.
I
Set the door glass in the full-close position.
1.
Remove inside handle escutcheon A.
2.
Remove screw securing inside handle.
3.
Detach inside handle rod on the door lock assembly side.
NBT103
4.
Detach lock knob rod (on the door lock assembly side).
5.
Using a flat-bladed screwdriver, expand rod holder. Remove
rod from rod holder.
6.
Slide inside handle backward and remove inside handle.
7.
Remove rod from inside handle.
8.
Disconnect door lock actuator connector.
9.
Remove screws securing door lock assembly, then remove
door lock assembly.
10. Remove bolts securing outside handle, then remove outside
handle.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
DOOR
Rear Door Lock (Cont’d)
BT-21
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст