Nissan Almera Tino V10. Instruction — part 189
AT-480
[ALL]
REPAIR FOR COMPONENT PARTS
INSPECTION
Rear Internal Gear, Forward Clutch Hub and Overrun Clutch Hub
●
Check rubbing surfaces for wear or damage.
Snap Ring, End Bearings and Forward One-way Clutch
●
Check snap ring and end bearings for deformation and damage.
●
Check forward one-way clutch for wear and damage.
ASSEMBLY
1.
Install forward one-way clutch on forward clutch.
●
Take care with the direction of forward one-way clutch.
2.
Install end bearing on forward one-way clutch.
●
Apply petroleum jelly to bearing.
SAT256D
SAT257D
SAT976H
MCIB9019E
REPAIR FOR COMPONENT PARTS
AT-481
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
3.
Install thrust washer on rear internal gear.
●
Apply petroleum jelly to thrust washer.
●
Align hooks of thrust washer with holes of rear internal
gear.
4.
Install end bearing on rear internal gear.
●
Apply petroleum jelly to end bearing.
5.
Install forward clutch hub on rear internal gear.
●
Check operation of forward one-way clutch.
Hold rear internal gear and turn forward clutch hub.
Check forward clutch hub for correct locking and unlock-
ing directions.
●
If not as shown in illustration, check installation direction
of forward one-way clutch.
6.
Install thrust washer and overrun clutch hub.
●
Apply petroleum jelly to thrust washer.
●
Align pawls of thrust washer with holes of overrun clutch
hub.
7.
Install overrun clutch hub on rear internal gear.
●
Align projections of rear internal gear with holes of over-
run clutch hub.
SAT160F
MCIB9021E
SAT713H
SAT263D
SAT264D
AT-482
[ALL]
REPAIR FOR COMPONENT PARTS
8.
Install snap ring to groove of rear internal gear.
Output Shaft, Idler Gear, Reduction Pinion Gear and Bearing Retainer
ECS009CR
COMPONENTS
DISASSEMBLY
1.
Remove seal rings from output shaft and bearing retainer.
SAT248D
SAT487JA
SAT644D
REPAIR FOR COMPONENT PARTS
AT-483
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
2.
Remove output shaft bearing with screwdrivers.
●
Always replace bearing with a new one when removed.
●
Do not damage output shaft.
3.
Remove snap ring from bearing retainer.
4.
Remove needle bearing from bearing retainer.
5.
Remove idler gear bearing inner race from idler gear.
6.
Remove idler gear bearing outer race from transmission case.
SAT645D
SAT646D
AAT539
SAT648D
AAT495
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст