Nissan Murano. Instruction — part 1180
RF-104
< REMOVAL AND INSTALLATION >
SUNSHADE MOTOR ASSEMBLY
SUNSHADE MOTOR ASSEMBLY
Exploded View
INFOID:0000000009719694
FOR STANDARD SPECIFICATION
JMKIA6375GB
1.
Roof side finisher RH
2.
Rear link cover
3.
TORX bolt
4.
Glass lid
5.
Inner blind
6.
Sunroof unit assembly
SUNSHADE MOTOR ASSEMBLY
RF-105
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
7.
Sunroof bracket
8.
Drain plug
9.
Drain hose
10. Drain connector
11.
Roof side finisher LH
12. Sunroof motor assembly
13. Sunshade motor assembly
14. Deflector knock RH
15. Deflector knock LH
: Pawl
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
,
,
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
RF-106
< REMOVAL AND INSTALLATION >
SUNSHADE MOTOR ASSEMBLY
FOR HIGH DURABILITY SPECIFICATION
JMKIA6509GB
1.
Roof side finisher RH
2.
Rear link cover
3.
TORX bolt
4.
Glass lid
5.
Inner blind
6.
Sunroof unit assembly
7.
Sunroof bracket
8.
Drain plug
9.
Drain hose
10. Drain connector
11.
Roof side finisher LH
12. Sunroof motor assembly
13. Sunshade motor assembly
14. Deflector knock RH
15. Deflector knock LH
: Pawl
SUNSHADE MOTOR ASSEMBLY
RF-107
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
Removal and Installation
INFOID:0000000009719695
REMOVAL
CAUTION:
• Before removing sunshade motor, check that glass lid is fully closed.
• After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit.
1.
Remove the headlining. Refer to
INT-30, "SUNROOF : Removal and Installation"
2.
Disconnect connector (A) from sunshade motor assembly (1).
Remove sunshade motor assembly mounting screws (B), and
then remove sunshade motor assembly
INSTALLATION
CAUTION:
Before installing the sunshade motor assembly, be sure to the place the link and wire assembly in the
symmetrical and fully closed position.
1.
Move the sunshade motor assembly laterally by little so that the gear is completely engaged into the wire
on the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunshade motor
assembly with screws.
2.
Install the headlining. Refer to
INT-30, "SUNROOF : Removal and Installation"
.
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
,
,
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIA1909ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст